Summary of IKE197-9
Page 1
User manual refrigerator ike197-9.
Page 2
Contents safety information 2 operation 4 first use 4 daily use 4 helpful hints and tips 5 care and cleaning 6 what to do if… 7 technical data 9 installation 9 environmental concerns 13 subject to change without notice safety information in the interest of your safety and to ensure the correct use, ...
Page 3
• it is dangerous to alter the specifications or modify this product in any way. Any dam- age to the cord may cause a short-circuit, fire and/or electric shock. Warning! Any electrical component (power cord, plug, compressor) must be replaced by a certified service agent or qualified service personn...
Page 4
Environment protection this appliance does not contain gasses which could damage the ozone layer, in either its refrigerant circuit or insulation materials. The appliance shall not be dis- carded together with the urban refuse and rubbish. The insulation foam con- tains flammable gases: the applianc...
Page 5
Positioning the door shelves to permit storage of food packages of vari- ous sizes, the door shelves can be placed at different heights. To make these adjustments proceed as fol- lows: gradually pull the shelf in the direction of the arrows until it comes free, then reposition as required. Humidity ...
Page 6
Causing frost or ice on the evaporator. If this happens, set the temperature regu- lator toward warmer settings to allow au- tomatic defrosting and so a saving in elec- tricity consumption. Hints for fresh food refrigeration to obtain the best performance: • do not store warm food or evaporating liq...
Page 7
Periods of non-operation when the appliance is not in use for long pe- riods, take the following precautions: • disconnect the appliance from elec- tricity supply • remove all food • defrost 3) and clean the appliance and all accessories • leave the door/doors ajar to prevent un- pleasant smells. If...
Page 8
Problem possible cause solution water flows on the rear plate of the refrigerator. During the automatic defrosting process, frost defrosts on the rear plate. This is correct. Water flows into the re- frigerator. The water outlet is clogged. Clean the water outlet. Products prevent that water flows i...
Page 9
Technical data dimension of the recess height 1030 mm width 560 mm depth 550 mm the technical information are situated in the rating plate on the internal left side of the ap- pliance and in the energy label. Installation read the "safety information" carefully for your safety and correct operation ...
Page 10
Ventilation requirements the airflow behind the appliance must be sufficient. Min. 200 cm 2 min. 200 cm 2 installing the appliance caution! Make sure that the mains cable can move freely. Do the following steps: 1. Install the appliance in the niche. Push the appliance in the direction of the arrows...
Page 11
I 4. Push the sealing strip between the ap- pliance and the adjacent cabinet. 5. Remove the correct part from the hinge cover (e). Make sure to remove the part dx, in the case of right hinge, sx in op- posite case. 6. Attach the covers (c, d) to the lugs and the hinge holes. Attach the hinge covers ...
Page 12
Ha hc 10. Open the appliance door and the kitchen furniture door at an angle of 90°. Insert the small square (hb) into guide (ha). Put together the appliance door and the furniture door and mark the holes. Ha hb 8 mm 11. Remove the brackets and mark a dis- tance of 8 mm from the outer edge of the do...
Page 13
• the magnetic sealing strip is attached tightly to the cabinet. Important! If the ambient temperature is low (for example, in the winter), the size of the gasket decreases. The size of the gasket increases when the ambient temperature increases. Environmental concerns the symbol on the product or o...
Page 14
14.
Page 15
15.
Page 16
212710201-00-16042009.