1. DL manuals
  2. Küppersbusch
  3. Freezer
  4. IKE237-7-2T
  5. User Manual

Küppersbusch IKE237-7-2T User Manual

Manual is about: fridge-freezer

Summary of IKE237-7-2T

  • Page 1

    Gebruiks- aanwijzing koel-vries- combinatie user manual fridge-freezer notice d'utilisation réfrigérateur/ congélateur benutzer- information kühl-gefrier- schrank ike3260-1-2t.

  • Page 2

    Contents safety information 16 operation 18 first use 18 daily use 18 helpful hints and tips 20 care and cleaning 21 what to do if… 22 technical data 24 installation 24 environmental concerns 29 subject to change without notice safety information in the interest of your safety and to ensure the corr...

  • Page 3

    Warning! Any electrical component (power cord, plug, compressor) must be replaced by a certified service agent or qualified service personnel to avoid hazard. 1. Power cord must not be lengthened. 2. Make sure that the power plug is not squashed or damaged by the back of the appliance. A squashed or...

  • Page 4

    Service • any electrical work required to do the servicing of the appliance should be car- ried out by a qualified electrician or com- petent person. • this product must be serviced by an au- thorized service centre, and only genu- ine spare parts must be used. Environment protection this appliance ...

  • Page 5

    Place the fresh food to be frozen on the top compartment. Storage of frozen food when first starting-up or after a period out of use, before putting the products in the compartment let the appliance run at least 2 hours on the higher settings. If large quantities of food are to be stored, remove all...

  • Page 6

    Helpful hints and tips hints for energy saving • do not open the door frequently or leave it open longer than absolutely necessary. • if the ambient temperature is high and the temperature regulator is set to low temperature and the appliance is fully loaded, the compressor may run continu- ously, c...

  • Page 7

    Care and cleaning caution! Unplug the appliance before carrying out any maintenance operation. This appliance contains hydrocarbons in its cooling unit; maintenance and re- charging must therefore only be carried out by authorized technicians. Periodic cleaning the equipment has to be cleaned regula...

  • Page 8

    Sin underneath to collect the defrost water in order to speed up the defrosting process, place a pot of warm water in the freezer compartment. In addition, remove pieces of ice that break away before defrosting is complete. 4. When defrosting is completed, dry the interior thoroughly and keep the sc...

  • Page 9

    Problem possible cause solution the compressor oper- ates continually. The temperature is not set cor- rectly. Set a higher temperature. The door is not closed correctly. Refer to "closing the door". The door has been opened too frequently. Do not keep the door open longer than necessary. The produc...

  • Page 10

    Closing the door 1. Clean the door gaskets. 2. If necessary, adjust the door. Refer to "installation". 3. If necessary, replace the defective door gaskets. Contact the service center. Technical data dimension of the recess height 1780 mm width 560 mm depth 550 mm rising time 24 h voltage 230-240 v f...

  • Page 11

    Ance to a separate earth in compliance with current regulations, consulting a qualified electrician. The manufacturer declines all responsibility if the above safety precautions are not ob- served. This appliance complies with the e.E.C. Di- rectives. Door reversibility the door of the appliance ope...

  • Page 12

    Min. 200 cm 2 50 - min. 200 cm 2 installing the appliance caution! Make sure that the mains cable can move freely. Do these steps. 1. If necessary cut the adhesive sealing strip and then apply it to the appliance as shown in figure. X x 2. Install the appliance in the niche. Push the appliance in th...

  • Page 13

    I 5. Remove the correct part from the hinge cover (e). Make sure to remove the part dx, in the case of right hinge, sx in op- posite case. 6. Attach the covers (c, d) to the lugs and the hinge holes. Install the vent grille (b). Attach the hinge covers (e) to the hinge. B e e d c 7. Connect the appl...

  • Page 14

    Ha hb hc hd 9. Install the part (ha) on the inner side of the kitchen furniture. Ca. 50 mm ca. 50 mm 21 mm 90° 90° 21 mm 10. Push the part (hc) on the part (ha). Ha hc 11. Open the appliance door and the kitch- en furniture door at an angle of 90°. Insert the small square (hb) into guide (ha). Put t...

  • Page 15

    Hb 14. Press the part (hd) on the part (hb). Hb hd do a final check to make sure that: • all screws are tightened. • the sealing strip is attached tightly to the cabinet. • the door opens and closes correctly. Environmental concerns the symbol on the product or on its packaging indicates that this p...

  • Page 16

    222346786-a-082011.