Summary of IKE326-0-2T-CN
Page 1
用户手册 冷冻冷藏箱 user manual fridge-freezer ike326-0-2t-cn.
Page 2
Warning! Any electrical component (power cord, plug, compressor) must be replaced by a certified service agent or qualified service personnel. 1. Power cord must not be lengthened. 2. Make sure that the power plug is not squashed or damaged by the back of the appliance. A squashed or dam- aged power...
Page 3
• this product must be serviced by an au- thorized service centre, and only genuine spare parts must be used. Environment protection this appliance does not contain gasses which could damage the ozone layer, in either its refrigerant circuit or insulation materials. The appliance shall not be dis- c...
Page 4
Partment let the appliance run at least 2 hours on the higher settings. If large quantities of food are to be stored, remove all drawers and baskets from appli- ance and place food on cooling shelves to obtain the best performance. Warning! Make sure that foods do not exceed the load limit stated on...
Page 5
Tomatic defrosting and so a saving in elec- tricity consumption. Hints for fresh food refrigeration to obtain the best performance: • do not store warm food or evaporating liq- uids in the refrigerator • do cover or wrap the food, particularly if it has a strong flavour • position food so that air c...
Page 6
• rinse and dry thoroughly. Important! Do not pull, move or damage any pipes and/or cables inside the cabinet. Never use detergents, abrasive powders, highly perfumed cleaning products or wax polishes to clean the interior as this will dam- age the surface and leave a strong odour. Clean the condens...
Page 7
4. When defrosting is completed, dry the in- terior thoroughly and keep the scraper for future use. 5. Switch on the appliance. 6. After two or three hours, reload the pre- viously removed food into the compart- ment. Warning! Never use sharp metal tools to scrape off frost from the evaporator as yo...
Page 8
Problem possible cause solution the door has been opened too frequently. Do not keep the door open longer than necessary. The product temperature is too high. Let the product temperature de- crease to room temperature before storage. The room temperature is too high. Decrease the room temperature. W...
Page 9
Closing the door 1. Clean the door gaskets. 2. If necessary, adjust the door. Refer to "in- stallation". 3. If necessary, replace the defective door gaskets. Contact the service center. Technical data dimension of the recess height 1780 mm width 560 mm depth 550 mm rising time 24 h the technical inf...
Page 10
Door reversibility the door of the appliance opens to the right. If you want to open the door to the left, do these steps before you install the appliance: 1. Loosen and remove the upper pin. 2. Remove the upper door. 3. Remove the spacer. 4. Loosen the middle hinge. 5. Remove the lower door. 6. Loo...
Page 11
1 2 2. Adjust the appliance in the niche. The lower hinge cover (in the accesso- ries bag) makes sure that the distance between the appliance and the kitchen furniture is correct. Open the door. Put the lower hinge cover in position. 44mm 4mm 3. Attach the appliance to the niche with 4 screws. I 4. ...
Page 12
Install the vent grille (b). Attach the hinge covers (e) to the hinge. B e e d c 7. Connect the appliance laterally to the kitchen furniture sidewall: a) loosen the screws of the part (g) and move the part (g) till the furniture sidewall. B) tighten the screws of the part (g) again. C) attach the pa...
Page 13
Put together the appliance door and the furniture door and mark the holes. Ha hb 8 mm 12. Remove the brackets and mark a dis- tance of 8 mm from the outer edge of the door where the nail must be fitted (k). Ha k 8 mm 13. Place the small square on the guide again and fix it with the screws supplied. ...
Page 14
26.
Page 15
27.
Page 16
222329174-00-042010