Instruction manual kussmaul electronics co., inc . 170 cherry ave., west sayville, n.Y. 11796 file: 091-84.P65 date: 06-02-99 tel: in ny 631-567-0314 toll free: 800-346-0857 fax: 631-567-5826 engine idler module part of a high idle system 3 year warranty engine idler model #091-84-005 voltgae monito...
Introduction the high idle system consists of a model 091-84-005 engine idler and a model 091-84-004 voltage monitor. The system permits a vehicle operator to increase engine rpm to obtain more alternator output. Rpm may be increased manually from the engine idler or automati- cally from the voltage...
Installation typical installations are illustrated in figures 1 through 4. Mount actuator and solenoid valve in an appropriate location and connect the actuator output to the throttle mechanism. (note: the actuator and solenoid valve must be purchased seperately. Kits that simplify the actuator moun...
Test procedure 1. With the transmission switch in park turn the ignition switch the accessory position. The led on the engine idler should remain off. 2. Press the "on" switch on the engine idler. The led on the engine idler should turn on. 3. Move the transmission to drive or reverse. The led on th...
Ford, in many installations uses a starter solenoid which has one side of the coil grounded. The neutral safety switch is then placed in the supply side of the solenoid coil. This configuration creates a considerable voltage spike when the vehicle is started. A diode must be placed across the starte...
Kussmaul engine idler on off engine idler installation battery + neutral safety switch close in neutral/park brake light diode on some vehicles install diode to prevent emergency flasher or turn signals from turning off the engine idler to +12 volts thru accessory position of ignition switch figure ...
Kussmaul engine idler on off engine idler installation to +12 volts thru accessory position of ignition switch figure 2 1 amp fuse in o ut source for engines with neutral safety switch connected to starter note: some engines have one side of starter solenoid at ground and the neutral safety switch i...
Kussmaul kussmaul engine idler voltage monitor on low off high battery + neutral safety switch close in neutral/park brake light diode on some vehicles install diode to prevent emergency flasher or turn signals from turning off the engine idler to +12 volts thru accessory position of ignition switch...
Kussmaul kussmaul engine idler voltage monitor on low off high installation and wiring diagram in o ut source battery + brake light diode on some vehicles install diode to prevent emergency flasher or turn signals from turning off the engine idler to +12 volts thru accessory position of ignition swi...
Bracket to support switch linkage to transmission transmission switch used to sense when vehicle is in park. This is a momentary switch that connects a ground to pin 4 on the engine idler vehicle shown in park to pin 4 engine idler ground for vehicles that do not have a neutral safety switch or have...
Installation record & warranty date installed installed by vehicle identification vehicle owner warranty all product of kussmaul electronics company inc. Are warranted to be free of defects of material or workmanship. Liability is limited to repair- ing or replacing at our factory, without charge, a...
