KUSSMAUL 091-84-005 Instruction Manual

Summary of 091-84-005

  • Page 1

    Instruction manual kussmaul electronics co., inc . 170 cherry ave., west sayville, n.Y. 11796 10-19-96 tel: in ny 631-567-0314 toll free: 800-346-0857 fax: 631-567-5826 engine idler module part of a high idle system 3 year warranty engine idler model #091-84-005.

  • Page 2: Introduction

    Introduction the 091-84-005 engine idler model is part of a high idle system that can be installed on either gasoline or diesel engines. This device permits a vehicle operator to increase engine rpm to obtain more alternator output. In order to move the throttle mechanism or interface with electroni...

  • Page 3: Installation

    Installation typical installations on gasoline and diesel engines are illustrated in figures 1 and 2. Mount actuator and solenoid valve in an appropriate location and connect the actuator output to the throttle mechanism. (note: the actuator and solenoid valve must be purchased seperately. Be certai...

  • Page 4: Test Procedure

    Test procedure 1. With the transmission switch in park turn the ignition switch to the accessory position. The led on the engine idler should remain off. 2. Press the "on" switch on the engine idler. The led on the engine idler should turn on. 3. Move the transmission to drive or reverse. The led on...

  • Page 5: Ford Installations

    Ford, in many installations uses a starter solenoid which has one side of the coil grounded. The neutral safety switch is then placed in the supply side of the solenoid coil. This configuration creates a considerable voltage spike when the vehicle is started. A diode must be placed across the starte...

  • Page 6

    Kussmaul engine idler on off engine idler installation for gasoline engines with a vacuum source battery + neutral safety switch close in neutral/park brake light diode on some vehicles install diode to prevent emergency flasher or turn signals from turning off the engine idler to +12 volts thru acc...

  • Page 7

    Kussmaul kussmaul engine idler voltage monitor on low off high installation and wiring diagram in o ut 091-84-vv battery + brake light diode on some vehicles install diode to prevent emergency flasher or turn signals from turning off the engine idler to +12 volts thru accessory position of ignition ...

  • Page 8

    Kussmaul kussmaul engine idler voltage monitor on low off high battery + neutral safety switch close in neutral/park brake light diode on some vehicles install diode to prevent emergency flasher or turn signals from turning off the engine idler to +12 volts thru accessory position of ignition switch...

  • Page 9: Warranty

    Installation record & warranty date installed installed by vehicle identification vehicle owner warranty all product of kussmaul electronics company inc. Are warranted to be free of defects of material or workmanship. Liability is limited to repair- ing or replacing at our factory, without charge, a...