KUSSMAUL Auto-Pump 091-9HP Instruction Manual

Summary of Auto-Pump 091-9HP

  • Page 1

    Instruction manual tel: in ny 631-567-0314 toll free: 800-346-0857 fax: 631-567-5826 1 year warranty file: 091-9hp.Pm6.5 date: 11-17-04 kussmaul electronics co., inc . 170 cherry ave., west sayville, n.Y. 11796 input: 120 volt, 60 hz, 4.0 amps ® auto-pump hp 120 vac high pressure air compressor syst...

  • Page 2: Note

    Introduction the 091-9hp auto-pump air compressor system is a 120 volt 60 hz split capacitor a.C. Motor operating a single cylinder air compressor designed specifically for installation on vehicles with air brakes. During long idle periods of the vehicle when even the slightest seepage can cause an ...

  • Page 3: Caution

    Caution no condensate or water must be allowed to enter or accumulate in the output of the auto pump. Route output pressure line downward from auto pump to permit moisture to drain away. Condensate trap must be drained weekly water in the pump outlet will induce failure ! Water damage will void warr...

  • Page 4

    Vehicle tubing installation 1. Mount all components in a suitable location, preferably in a high area above the air system . Do not mount in engine compartment or near any source of heat or dirt . The system may be connected to any point in the vehicle's air system . 2. Mount air compressor in a ver...

  • Page 5

    Vehicle wiring installation 1. The auto pump is supplied with a 120 volt a.C. Line cord and is ready to operate. The line cord may be plugged into an available outlet or the cord may be cut and permanently wired to the 120 volt a.C. System in the vehicle. Specification input : 120 volts a.C. 60 hz, ...

  • Page 6

    Warranty all auto pumps of kussmaul electronics company inc. Are warranted to be free of defects of material or workmanship. Liability is limited to repairing or replacing at our factory, without charge, any material or defects which become apparent in normal use within 1 year from the date the equi...