Kustom Bass Guitar Speaker Cabinet G115H Owner's Manual - Horn Attenuator:

3

1

Horn Attenuator:

3

Speaker Input/Output

:  

 This is a “volume” control for the 

These jacks can be used as an input 

horn.  To disable the horn, turn the 

and/or output.  They accept standard 

knob counter clockwise until the 

Speakon

d

 type speaker cables.  To 

indicator reaches 

:

.  To set the horn 

connect a cable: Insert and twist one 

quarter turn clockwise until the release 

for maximum output, turn the knob 

button locks.  To remove a cable:  Pull 

clockwise until the indicator reaches 0.

back release button on cable connector, 

twist connector counter clockwise one 

2

Speaker Input/Output:

These jacks can be used as an input 

quarter turn, and pull out connector.  

and/or output.  The jacks accept a 

Note:  When using these jacks as an 

output to another cabinet, refer to the 

standard 

¼

” cable.  Note:  When using 

Amplifier Loading Chart (page 4) for 

these jacks as an output to another 

important amplifier loading information.

cabinet, refer to the Amplifier Loading 

Chart (page 4) for important amplifier 

loading information. 

4

HORN ATTENUATION dB

Designed by Kustom Inc. Hebron, Kentucky

MADE IN CHINA

+1 tip, -1 sleeve

INPUT/OUTPUT

+1 and -1 used

0

1

2

3

5

6

7

8

10

12

16

MODEL: G115H

XXXX-XXXXXX

IMPEDANCE: 8 OHMS

POWER:

450 WATTS RMS

SENSITIVITY:97dB 1W/1M

1

2

3

Rear Panel