Kustom KHS-240V Owner's Manual
OWNER’S MANUAL
MODEL KHS-24OV
MODEL KHS-240V
IMPORTANT SAFEGUARDS
1)
2)
3)
4)
5)
6)
7)
READ ALL INSTRUCTIONS, RETAIN THESE INSTRUCTIONS,
HEED ALL WARNINGS, FOLLOW ALL INSTRUCTIONS!!!
WATER AND MOISTURE - This amplifier should NOT be
used
near water-such as near a bathtub, washbowl, kitchen sink,
laundry tub, in a wet basement or near swimming pool, etc.
HEAT - This amplifier should be located away from heat sources,
such as heat registers, stoves, or other heat producing items.
VENTILATION - The amplifier should be located in such a way
as to promote adequate ventilation.
POWER CORD PROTECTION - The power cord should be
routed in such a way as to protect it from being
walked on,
pinched, or otherwise damaged.
OBJECT AND LIQUID ENTRY - Care should be taken
to
prevent
liquids or foreign objects from entering the amplifier cabinet.
SERVICING - The user should NOT attempt to service this
amplifier. There are
NO user-serviceable parts contained within.
FEATURES
6 Discrete Stereo Amplifiers in one chassis, 240 Watts Total
Output Power.
A Discrete Amplifier for each room or zone provides higher
performance and lower distortion than impedance Matchers
and Autoformers.
Uses a Line Level input signal from virtually any stereo system.
The Full Output Power of your stereo system is reserved for
the main listening room, Not Dissipated throughout the home.
“Pass Through” Source Outputs to “Daisy Chain” multiple
amplifiers for 12, 18 or more Rooms or Zones.
A or B Input Selection for even more flexibility.
Full Complement of Protective Circuits for Ultimate Reliability.
Optional Remote Room Volume Controls wire back to Amplifier
with simple 4 conductor “Telephone” wire, using RJ-45 Modular
jacks.
Optional Remote Room Volume Controls with Infrared Repeating
allows for Remote Control of your centrally located components
from any room in the home.
4 Infrared Output ports accept virtually any brand of Emitter,
Flasher, or Blaster
FRONT PANEL CONTROLS AND OPERATION
A)
B)
C)
D)
E)
F)
G)
MASTER POWER BUTTON - Completely shuts down amplifier
for extended periods of non-use.
STANDBY ON L.E.D.-Indicates amplifier is at “idle,” awaiting
an incoming signal.
POWER ON L.E.D. - Indicates amplifier is receiving an incoming
signal and is operating normally.
ZONE MASTER VOLUME CONTROLS - An individual volume
control for each of the 6 rooms or zones. NOTE: If Optional
Remote volume Controls are used, the Master Volume
Controls can be set to limit the available power in each room.
INPUT SELECTOR - Selects Input A or B. NOTE: Whichever
input is selected will be available to all 6 rooms or zones.
INPUT A L.E.D. - Indicates that Input A is available.
INPUT B L.E.D. - Indicates that Input B is available.