Kutai Electronics EA05A-B Operation Manual - page 2
______________________________________________________________________________________
2
EA05A-B
1. SPECIFICATION
Sensing Input
Voltage
95~130 VAC, 1 phase2 wire
Frequency
50 / 60 Hz, DIP switch selectable
Power Input
Voltage
50 ~ 150 VAC, 1 phase 2 wire
Output
Voltage
Max. 45 VDC @ 120 VAC input
Current
Continuous 5A
Intermittent 7A for 10 sec
Resistance
Min. 15 ohm Max. 100 ohm
Voltage Regulation
Voltage Build-up
Residual voltage at AVR terminal > 5 VAC
Thermal Drift
0.03% per
°
C change in AVR ambient
External Volts Adjustment
7% with 1K ohm 1 watt trimmer
EMI Suppression
Internal electromagnetic interference filtering
Unit Power Dissipation
Max. 8 watt
Under Frequency Protection (Factory Setting)
60 Hz system presets knee point at 55 Hz
50 Hz system presets knee point at 45 Hz
Soft Start Ramp Time
3 sec.
Dimensions
101mm L * 69mm W * 47.5mm H
Weight
183g ± 2%
2. WIRING
When generator supply is over load, N phase will be
different with the sharing load by 3 phases (load
imbalance). Hence, the voltage from N phase to 3
phases (R.S.T.) will be altered. When the rated
voltage of the traditional single input’s AVR is above
110V, it will increase the voltage drift rate by using N
phase as the detective input. It will also cause the
voltage imbalance.
EA05A-B can improve the above situation, and
increase the generator’s rated voltage usage space,
such as 110V. We can all detect by the “phase
voltage”.
1. When the rated phase voltage of the generator is
110VAC, the input terminals B, C and sensing
terminals A, C can join together (as show as
figure3. It’s the original setting).or connect
independent.(as show as Figure3).
2. When the rated phase voltage of the generator is
110V, the input terminals B, C and sensing
terminals A, C must separate connect the wiring
(as show as Figure 3). The voltage between B
and C must not be over 300 VAC.
3. F+ F- terminals connect to the generator field. ( J
and K )
FEXT.VR is the potentiometer (1K
Ω
1W). These two
terminals
must
be
by-pass
when
external
potentiometer is needless.
P.S. : A, B, C, F+ F- the usage of wire gauge are
AWG16 or 1.25mm
2
85
°
C above 600V.
The EXT.VR connection wires must be made of
isolated wiring.
3. ADJUSTMENTS
The voltage setting for 110V and the frequency
setting for 50/60HZ is show in Figure3. Please
check the voltage/frequency selector setting is
correct before start the generator.
CAUTION :
The generator or AVR may be damaged if the
voltage / frequency selector setting is incorrect.
UFRO DIP:
Close - please refer to solid curve in Figure5.
Open - please refer to dotted curve in Figure5.
1. Before you turn on the generator, please turn the