Kuvings NS-995UL Instruction Manual - page 5
Assemble the entire top set onto the base.
- Align the mark on the top set unit into on the
base unit. Turn the top set unit clockwise to match
mark and mark of the base unit.
08
09
How to assemble the parts to a base unit
Disassembly is the reverse steps of assembly steps.
Before attaching Juicing bowl to the base unit, check if the pulp extraction silicon is adjusted properly.
If pulp extraction silicon is not adjusted properly, juice can leak outside of the juicing bowl and the amount
of juice would be less.
1
2
Make sure the red dot on the strainer
and the red dot on the bowl is aligned.
Place the strainer into a rotation wiper.
Connect the lid and the bowl through
the red spot assemble mark and
assemble it by turning it the clock-wise.
Insert the Juicing screw into center
of strainer.
GSpin and push the juicing screw
while inserting into the strainer.
Assembly position mark
Assembly position mark
Juicing Bowl
assemble mark
Juicing Bowl
assemble mark
GMake sure the red spot on the lid
and the red spot on the bowl is aligned.
Juicing Bowl
assemble mark
Strainer assemble mark
Place the strainer and wiper
into the bowl properly.
Stainer + Juicing Bowl
Juicing Bowl
Juicing Bowl
Drum (Lid)
Strainer
Juicing Bowl
6OEFSOFBUIUIF#PXM
5IJTQBSUJT
EFUBDIBCMF
GPSDMFBOJOH
The pulp extraction silicon has to be attached to the pulp outlet. Always insert the rubber gasket properly before use.
Strainer
Rotation wiper
Screw
Place the pulp container under the base
hook.
Place the juice cup properly.
Turn the lid towards ‘close’ mark.
Turn the Lid clock-wise until mark
on the lid is alignment with mark on
the juicing bowl unit.
*OTFSUJPO%JSFDUJPO
'JSNMZ*OTFSUJPO
Base hook