Kuvings NS-995UL Manual - page 5
9
88
HOW TO ASSEMBLE
Firmly insert the compression silicone
into the slot below the pulp spout.
The Juicer may leak if not assembled
properly.
Note |
The juicing screw needs to be locked in
place in order to close the drum lid.
Note |
Juicer will not operate if parts are not
assembled properly.
Note |
STEP 1
Top-set Assembly
STEP 2
Top-set and Base Assembly
Assemble the strainer into the rotation
wiper then place this assembly in to the
juicing bowl ensuring the red dot
ⷅ
on
the strainer is aligned with the red dot
ⷅ
on the juicing bowl.
Place the juicing screw into the strainer.
Turn and press down on it until it clicks
into place.
Place the drum lid on to the juicing bowl
aligning the red dot
ⷅ
on the drum lid
with the red dot
ⷅ
on the juicing bowl.
Turn clockwise to close, aligning the red
dot
ⷅ
on the drum lid with the close
mark .
Silicone Parts
Silicone parts are washable. Properly
assemble after washing.
• Push in the silicone ring with the smaller
surface facing down.
• Insert into the slot with the tail pointing
down as shown in the illustration.
Tail
Check Before
Operating
• Wash the parts before fi rst use.
• Ensure that the compression silicone and silicone ring are assembled properly.
1
2
3
4
Place the pulp cup under the pulp spout
and place the juice cup under the juice
spout as shown in the illustration.
.
7
Detachable
Open/Close mark on the top-set.
6
Open
Close
5
Place the drum lid on the juicing bowl.
Align the down arrow
ⶼ
on the drum lid
with the OPEN mark on the base and
turn to the CLOSE position.
EN