KV2 Audio VHD 2000 Operator's Manual - Features
FEATURES
1) Main Input / Through Signal Out
This is the main system input connector with associated ‘Through Signal Output’ connector for sending
unprocessed signal to other devices, such as more VHD 2000’s to power more VHD 2.0’s in a system.
2) Mid/High In / Pre Control Out
This is an insert point for the Mid/High section of the VHD 2000, the signal sent to the
VHD 2.0 cabinet. It enables you to ‘insert’ an external device (a delay line for example) into the
signal that is being sent to the VHD 2.0. With the associated switch in the ‘Engage’ setting the
Pre Control Out connector would send the signal to the external device, and its output would
be returned into the Mid/High In connector.
3) Sub-A In / Sub-A Out , Sub B-In / Sub-B Out
Apart from providing signal processing and power amplification for driving the VHD 2.0
enclosure the VHD 2000 also provides processed outputs for feeding VHD 3200 subwoofer
amplifiers to drive various combinations of subwoofers. The signal for this is usually derived
from the Main Input on the VHD 2000 but with these Sub In and Sub Out connectors and
associated switches the option is available to derive the signal input for the subwoofer
section from a different source. For further information see Using the System.
4) PowerCon Power Connector
Accepts a standard PowerCon terminated AC cable.
5) Fans
The cooling fans operate continuously while the VHD 2000 is on. An internal temperature
sensor increases the speed of the fans during high temperature conditions. Air enters through
the front grille and exits through the rear. Be sure to allow adequate air flow to the front
of the rack in which the VHD 2000 is mounted.
6) EP6 Connector
Accepts a standard EP6 terminated loudspeaker cable. We recommend using 2.5mm/core
cables, six core for the VHD 2.0 enclosure and four core for the VHD subwoofers EP4
connectors as all four connectors are used, when using a VHD 3200 subwoofer amplifier.
3
3.2 REAR PANEL
1
2
3
4
5
6