Kvaser PCIcan II User Manual - page 6
Document Number
P028-PCIcan II
Document Title
PCIcan II User's Guide
Revision
6
Project
P028-Doc
Responsible
P028
Approved
P028
Status
Released
- www.kvaser.com -
Page 6 of 14
2.2 Schematics
This chapter describes the three product variants of Kvaser PCIcan II.
2.2.1 PCIcan HS/HS - a two-channel full-height PCI board
This board has been manufactured in two versions:
•
A version that can be used in PCI slots with 5V signaling. This version was manufactured
until around June 2004. The part number was 00157-2.
•
A version that can be used both in PCI slots with 5V signaling and in PCI slots with 3.3V
signaling. The part number is 00235-7.
To determine which voltages your board requires, look at the voltage keying on the PCI connector.
Figure 1: The PCI connector with its voltage keying
•
If the board has two keys as seen in Figure 1, then it can be mounted in both 5V PCI slots and
3.3 V PCI slots.
The PCI standard refers to this type of card as “Universal cards”.
•
If the board has just the 5V key, then it requires a 5V PCI slot.
2.2.2 PCIcan II HS – a one-channel full-height PCI board
This is simply a one-channel version of the above board, with the exception that there is only one
version, which can handle both 5V and 3.3V PCI slots.