L.A. Spas IN-FIT Owner's Manual - page 16
15
rev. 2011-5-26
Leveler key is associated with the leveler swim jet. Press the Leveler key once to turn on the
leveler swim pump. Press the Leveler key again to turn off the pump.
5.
Spa Jets key:
Spa Jets key is associated with the therapy jets. Press the Spa Jets key once to turn the spa
pump on low speed. Press the Spa Jets key a second time to turn the spa pump on high speed.
Press the Spa Jets key the third time to turn off the pump.
6.
Main Light key:
Press the Main Light key once to turn on the LED lights. Press the Main Light key a second time
to turn off the LED lights. To select a specific color, after the LED lights have been turned off,
press the Main Light key within 10 seconds to change to the next color selection. Continue until
the desired color is reached. The color setting will store in the memory when the LED lights are
turned off for more than 30 seconds. This feature allows the user to retain a favorite color setting.
A total of 10 color settings are available:
- Ice
- Blue
- Red
- Green
- Sunburst (yellow and orange glow)
- Magenta (blue and red glow)
- Tidal (fade between blue and green)
- Afterburner (fade between red and yellow)
- Color Burst Fast (entire color spectrum)
- Color Burst Slow (entire color spectrum)
7.
Swim Light key:
Press the Swim Light key once to turn on the swim LED light. Press the Swim Light key a
second time to turn off the swim LED light. To select a specific color, after the LED lights have
been turned off, press the Swim Light key within 10 seconds to change to the next color selection.
Continue until the desired color is reached. The color setting will store in the memory when the
swim LED light is turned off for more than 30 seconds. This feature allows the user to retain a
favorite color setting. See above for the 10 color settings.
8. Invert
key:
The Invert key is used to invert the display on the control panel.
9.
Warm and Cool keys:
Press the Warm key to increase the set temperature. Press the Cool key to decrease the set
temperature. The current spa water temperature will remain in the control panel display until a
temperature key is pressed. Once the desired water temperature has been set, the spa will begin
to heat. The default set temperature is 90°F (32°C).
Note: When selecting the spa operating temperature, it is important to factor in the outside ambient
temperature. A spa cannot operate at temperatures lower than that of the surrounding conditions,
or the operating environment of the spa. For the hot summer months, if cooler water is desired, the
Economy mode can be utilized.
10. Time
key:
Press the Time key to display the time on the control panel.
11. Mode/Prog
key: