L-Acoustics X8 User Manual - page 28
Maintenance
X8 user manual (EN) version 2.0
28
D/R - X8 DIAPHRAGM
How to remove and replace a X8 speaker diaphragm.
Tools
Name
Reference
Distributor
electric screwdriver with torque
selector
-
-
3 mm hex bit
EH.603
FACOM
Allen wrench n°3
-
-
Pre-requisite
Grill disassembled.
(p.24).
Coaxial speaker removed.
(p.26).
The speaker is placed on a flat surface in a dust-free
environment.
X8 diaphragm disassembly procedure
Procedure
1.
Remove the two screws securing the HF driver.
Use the 3 mm hex bit.
2.
Remove the HF driver and remove the gasket between the HF and LF driver.
3.
Place the HF driver on a flat surface.
4.
Remove the four screws securing the cover and remove the cover.
Use the 3 mm hex bit.
5.
Pierce the label and carefully remove the center screw while holding the cone in place.
Use the 3 mm hex bit.
Discard the paper disk to avoid parasitic vibrations.
6.
Remove the cone.
7.
Carefully remove the diaphragm holding it by the connectors.
8.
If there are black spacers on the air gap, do not remove them.
X8 diaphragm reassembly procedure
Procedure
1.
Clean the driver and the air gap.
Use a blower or double face adhesive tape to clean any particle.
Make sure the air gap is perfectly clean before moving to the next step.
2.
Carefully place the diaphragm.
If there are black spacers, make sure they remain in place.
3.
Position the diaphragm using the screw holes as reference points.
The connectors must be positionned halfway between two screw holes.
4.
Place the cone in the middle.