L.B. White Guardian Installation Instructions

Page of 4

Download

Bookmark us

WORLD PROVIDER - INNOVATIVE HEATING SOLUTIONS

411 Mason Street, Onalaska, WI 54650 • 800-345-7200 • 608-783-5691 • 608-783-6115 (fax) • www.lbwhite.com

Guardian

Flame Sensor Kit

View these instructions online at www.lbwhite.com

Kit Contents:

Tools required:

- 5/16 nut driver or standard screwdriver

- Wire cutting/stripper/crimping tool

- Heat gun, small hand-held torch, or butane lighter

DESCRIPTION

QTY.

Flame Sensor

Heat Shrink Tube

1/4” Male Quick Connect Terminal

Mounting Hardware

Installation Instructions

INSTALLATION INSTRUCTIONS

Qualifications for installation of the kit:

• You must be able to read and understand these instructions.

• You must be properly trained and have suffi cient experience to install the kits.

• You must be able to test the heater for proper operation and place the heater in a

continuing safe and normal operating condition.

Discussion:

• Use this kit to maintain corrosion resistance of the electrical connection when replacing the fl ame sensor.

• Depending on the service kit, not all the parts may be use.

Initial Preparation:

• Disconnect the heater from its electrical supply.

• Close all fuel supply valves to the heater.

• Open the heater’s access door at the gas inlet end of the heater.

Page 1
World provider - innovative heating solutions 411 mason street, onalaska, wi 54650 • 800-345-7200 • 608-783-5691 • 608-783-6115 (fax) • www.Lbwhite.Com guardian flame sensor kit view these instructions online at www.Lbwhite.Com kit contents: tools required: - 5/16 nut driver or standard screwdriver ...
Page 2
Guardian flame sensor kit www.Lbwhite.Com installation instructions • guardian flame sensor kit 2 a. Installation: 1. Using the screwdriver or nut driver, remove the fl ame sensor from the igniter bracket. See fig. 1. Guardian 100 shown. Fig. 1 2. For guardian 60/100: • compare the 2 fl ame sensor e...
Page 3
Guardian flame sensor kit installation instructions • guardian flame sensor kit 3 heat shrink tube fig. 5 b. Completion 1. Secure any excess of wire using the purse lock clip. 2. Close and latch the access door. 3. Reconnect the heater to its electrical supply. 4. Open all fuel supply valves to the ...
Page 4: Www.Lbwhite.Com
Contact your local l.B. White dealer for replacement parts and service. You may also call the l.B. White co., inc. At 1-800-345-7200, for assistance, or email us at customerservice@lbwhite.Com. Be sure that you have your heater model number and confi guration number when calling. Service world provi...