L-com HG2415G Installation Instructions

Page of 3

Download

Bookmark us

IP-00017 Rev. C – 05/05 Page 1 of 3

Installation Instructions

Models: HG2415G and HG2419G

Antenna Components Included:

(2) Antenna Grid Section Halves

(1) Antenna Feedhorn Assembly

(1) Feed Reflector

(1) Small Self-tapping Screw

(2) Mast Clamps

(1) Aluminum “L” Bracket

(8) #M5 Machine Screws w/nuts, flat and lock washers

Antenna Assembly Instructions:

Assemble the halves of the Reflector Grid using

(4) #M5 machine screws with lock washers, flat

washers and nuts as shown.

Reflector Grid

Lock Washer & Nut

Install the Feed Reflector to the front of the

Feedhorn using the small self-tapping screw.

Feed Reflector

Feedhorn

Small Self-Tapping Screw

#M5 Machine Screw

L-COM, INC. 45 BEECHWOOD DRIVE NORTH ANDOVER, MA 01845

WWW.L-COM.COM E-MAIL: SALES@L-COM.COM PHONE: 1-800-343-1455 FAX: 1-978-689-9484

Page 1
Ip-00017 rev. C – 05/05 page 1 of 3 installation instructions models: hg2415g and hg2419g antenna components included: (2) antenna grid section halves (1) antenna feedhorn assembly (1) feed reflector (1) small self-tapping screw (2) mast clamps (1) aluminum “l” bracket (8) #m5 machine screws w/nuts,...
Page 2
Ip-00017 rev. C – 05/05 page 2 of 3 hg2415g and hg2419g installation instructions determine the polarity which will be chosen for the antenna installation. The antenna can be installed either vertically or horizontally polarized. The two polarities are illustrated below: horizontal polarity vertical...
Page 3
Ip-00017 rev. C – 05/05 page 3 of 3 lives may be at risk ! Carefully observe these instructions and any special instructions that are included with the equipment you are installing. Important: look over the site before beginning any installation, and anticipate possible hazards, especially these: co...