L.R. Baggs Synapse User Manual - Manufacturer’S Guidelines
The speakers and electronics in the Synapse have been tested under relentless and grueling
conditions beyond the recommended use of the system. This was done in order to ensure
that the Synapse will withstand the everyday use and abuse of a roadworthy product.
However, as with all loudspeakers, some care is required:
1) Do not play in direct sunlight on very hot days for extended periods of time or the
speakers and/or power amp can overheat and be damaged.
2) Do not play at volume levels above the maximum specified SPL, when the clip lights or
limiter lights are continually lit while playing, or when there is audible distortion.
3) The Synapse is a full range PA system. Great care has been taken to add seamless limiting
and protection for the speakers so that many types of instruments and music can be
played through it. However, the Synapse uses an 8” woofer and may not sustain high
peak levels of energy below 75Hz for extended periods of time. Reduce the playing
level if playing low frequencies from a keyboard, bass guitar, recorded music, etc. or
pair with a subwoofer for low energy support.
4) The Synapse can play at high levels and is not as susceptible to hot spots due to its wide
dispersion. This helps reduce blaring high SPLs and feedback. However, as with all
speakers, be careful to not play at unsafe SPLs for extended periods of time so that
hearing loss does not occur. Also, do not bring microphones within range of the speaker
where feedback can occur. This can cause hearing loss and potentially damage the
Synapse drivers if done excessively.
5) The finishing, plastics, wood, and metal in the Synapse housing were selected for strength
and durability as well as their aesthetic properties. The provided slip cover will help
protect it, but is not intended to replace a tour road case if that is needed. Please protect
and secure the Synapse appropriately in cargo areas during transportation so that it will
continue to look as good as it sounds.