Pd1023 powered mixer owners manual and instruction guide.
Thank you for choosing the l2 audio pd1023 professional mixing console. We’re confident that your purchase will give you years of service and the high quality of sound reproduction that our customers have come to expect. We pride ourselves in designing the right product for the right application. We...
Introduction this manual is designed to help you get the most out of your l2 audio pd1023 powered mixing console. The pd1023 is a powered mixing desk. This means that the amplifiers are built in, consequently an external power amplifier is not required. Although designed specifically as a live sound...
4. Low cut 75hz. (channels 1-6 only) this prevents any frequencies below 75hz from entering the microphone mix. This helps prevent low rumble feedback that can sometimes occur. 5. Gain. This sets the level of the incoming microphone signal. The gain range is 10 – 60db. 6. Peak. This lights up when t...
18. Line -10db. (channels 7&8, 9&10 only) this reduces the gain of the channel by 10db. Use this facility if you are putting line level feeds such as playback, keyboards, etc into the stereo channels. 19. Mic gain. (channels 7&8, 9&10 only). This sets the level of the incoming microphone signal. The...
28. Stereo graphic equalizer. This allows you to cut or boost certain frequencies to help enhance the mix. The middle of each graphic is your 0db starting point. Frequencies tend to be cut or ‘notched out’ more than boosted. Ideal if you are in a room which does not have particularly good acoustics....
39. Mains switch. This is to switch the mixer on. Please be sure that the master sliders are down before switching on 40. Ac power connector. This is where the mains iec plugs in. It also houses the internal ac power fuse. 41. Outputs. These are the left and right or mono bridge outputs that connect...
