La Cornue AlberTine 36 User Manual & Installation & Service Instructions - page 32
INSTALLATION
Check the appliance is electrically safe and gas sound when you have finished.
30
Seal the Openings
Seal any openings in the wall behind the range and in the
floor under the range when hookups are completed.
IMPORTANT: When all connections are completed make
sure the flow of combustion and ventilation air to the range
is unobstructed.
Leveling
Place the range in its intended position taking care not to
twist it within the gap between the kitchen units as damage
may occur to the range or the units. Install the oven racks
in the oven. Check for levelness by placing a level or a cup,
partially filled with water, on one of the oven grids. If using a
spirit level, take two readings with the level placed diagonally
first in one direction and then the other.
The rollers can be adjusted to level the range. To adjust the
height of the rear of the range use the leveling tool supplied
to turn the adjusting nuts at the front bottom corners of the
range.
Assemble the Range
Installing the Control Knobs
The range is supplied with 5 burner control knobs. These are
for the gas controls to the left of the control panel (Fig.6-34).
There are also 2 oven control knobs (Fig.6-35).
Push the multi-function oven selector knob and temperature
knob on to the control spindles at the right hand side of the
control panel.
Installing the Handrail
Components (Fig.6-36)
Hand rail tube
1
End cap with Allen fixing screw
2
Plastic friction cup
2
White plastic disk
2
Hold a friction cup by the tabs on one end of the tube
(Fig.6-37). Add one of the white plastic disks (Fig.6-38).
Line up one of the end caps to the tube and push it on the
tube over the friction cup and disk (Fig.6-39).
Turn the tube over and push on the other end cap using the
second friction cup and disk, making sure that you do not
scratch or damage the first end piece and the that the two
end pieces are lined up correctly.
Install the assembled handrail on the projecting mounting
studs on the control panel and hold it in place by tightening
the Allen screws. The Allen screws should be on the underside
(Fig.6-40).
Installing the Door Handle
Assemble the door knob to the door knob base and screw it
to the mounting on the oven door. Hand tighten only – do
not use any tools (Fig.6-41).
ArtNo.280-0053 Door Knob Screw to Door
Fig.6-41
ArtNo.280-0046 Burner Knob 2
ArtNo.280-0047 Oven Knob
ArtNo.280-0048 Handrail Parts
Fig.6-35
ArtNo.280-0049 Handrail Fitting Endcaps A
ArtNo.280-0050 Handrail Fitting Endcaps B
ArtNo.280-0051 Handrail Fitting Endcaps C
Fig.6-36
Fig.6-37
Fig.6-38
ArtNo.280-0052 Handrail From Below
Fig.6-39
Fig.6-40
ArtNo.280-0044 Cornufe Knobs 5
ArtNo.280-0045 Burner Knob
Fig.6-34