La Crosse 308-807 Quick Setup Manual - page 8
15
Positioning the Wireless display
The Weather station provides the option of table standing or wall
mounting the unit, vertically or horizontally. Before wall mounting, please
check that the outdoor data can be received from the desired locations.
TO WALL MOUNT:
Fix a screw (not supplied) into the desired wall,
leaving the head extended out by about
0.2”
(5mm).
Place the weather station onto the screw, using the
hanging hole on the backside. Gently pull the
weather station down to lock the screw into place.
TABLE STAND:
Insert the stand to the back of the wireless display.
Place wireless display on desk or table in range of
the sensors.
POSITIONING THE WIND/THERMOHYGRO TRANSMITTER:
Important: Before mounting, be sure the monitor & anemometer are
within the effective transmission range (246 ft open air).
Note: To mount the anemometer, you need a mast (not supplied)
about 1 – 1.25 inches (2.54 – 3.1 cm) in diameter, and the hardware
necessary to fasten it to the mounting location.
x
Mount and ground the mast as directed in the instructions
provided by the mast.
16
x
Place the supplied U-shape metal plates around the mast.
Insert 4 pieces of the supplied Hex screws through the holes
of the U-shape plates and the holes on the anemometer’s
mounting bracket.
x
Be sure the wind vane is above the wind cup and the metal
bar of the anemometer is in horizontal level)
x
Tighten the supplied Hex nut onto both ends of each screw
Calibrate the wind direction:
x
Hold the directional vane so it points north until batteries
installed.
x
Install batteries and wait for the red LED light to flash twice.
x
Release the directional vane.
DIRECTIONAL
VANE
WIND CUPS
THERMOHYGRO
SENSOR
COMPASS-top of
directional vane