La Crosse 515-1316 Instruction Manual - page 5
ACTIVATE/DEACTIVATE ALARM:
Press and release the AL ON/OFF button to turn the time alarm on. The alarm icon will show above the seconds.
Press and release the AL ON/OFF button to turn the time alarm off. The alarm icon will disappear when the alarm is off.
SNOOZE TIME:
When the alarm sounds, press the SNOOZE button to trigger snooze alarm for 5 minutes. The alarm icon Zz will flash
when the snooze feature is active. To stop alarm for one day, press AL button, while in snooze mode. The alarm icon will
remain solid.
POSITION THE CLOCK:
When positioning the clock it is always best to have the front or the back facing Ft. Collins, Colorado for best WWVB
signal reception.
Wall Mount:
Insert three screws (not included) into the desired wall, about 3.9 inches (10 cm) apart. Leave the head of the screws
extended out by about 0.2” (5mm). Carefully hang the clock on the screws, using the hanging holes on the back of the
clock.
NOTE: Always ensures that the unit locks onto the screws before releasing.
Table stand:
Pull out the table-stand from the rear of the clock. Pull out from the bottom. Place on table or desk as desired.
SPECIFICATIONS:
Dimensions: 15.35 inches H x 19.09 inches W x 1.57 inches D
(39 cm H x 48.5 cm W x 4 cm D)
Power:
Requires three “C” IEC LR14 alkaline batteries (not included).
CARE AND MANITENANCE:
Replace batteries promptly when needed.
Important:
Do Not Mix Old and New Batteries
Do Not Mix Alkaline, Standard, or Rechargeable Batteries
Remove batteries when clock is not in use or when in storage.
Clean only with a soft cloth or paper towel. Do not use corrosive cleanser or chemical solutions on the clock.
Avoid placing clock in high humidity environments such as poolside or in a bathroom.
Keep clock clean and dry to avoid problems.
Do not expose clock to direct sunlight or extremely hot or cold temperatures.
Wall Hanging Holes
Function Buttons
Battery Compartment
Base Stand