La Crosse 519-1416 Quick setup manual - page 2
Model: 519-1416 www.lacrossetechnology.com/support Page | 2
Alarm
Bell Icon
GET STARTED
Step 1: Insert 3 new AA Alkaline batteries (not included) into the clock.
Observe the correct polarity.
Restart: If the time (12:00) is not displayed after 30 seconds, first, check the battery
polarity. Second, remove batteries from the clock for 15 minutes. Return to Step 1 above.
SET TIME
1. Hold button 7 (MODE) to enter time set mode.
2. Press button 2 or 6 (DOWN or UP) to adjust values.
3. Press button 7 (MODE) to confirm adjustments and move to the next item.
TIME SET ORDER:
1. WWVB time signal (On/Off)
2. Time Zone - 7 time zones
3. DST (Daylight Saving Time On/Off)
4. 12/24 hour time format
5. Hour
6. Minutes
7. Seconds
8. Month
9. Date
10. Year
Note: When you select WWVB OFF, Time Zone and DST disappear from the time setting
order.
Press button 7 (MODE) to exit, or wait 30 seconds without pressing buttons to
return to the normal time display.
TIME ALARM (“AL” will show in place of seconds)
1. Hold button 3 (ALARM) to enter alarm time set mode.
2. Press button 2 or 6 (DOWN or UP) to adjust ALARM TIME.
3. Press button 3 (ALARM) to confirm adjustments and move to the next item.
ALARM TIME SETTING ORDER: Hours, Minutes
Activate/Deactivate Time Alarm
•
Press button 3 (ALARM) once to view alarm time.
•
Press button 3 (ALARM) again to activate the alarm.
Once activated the bell icon appears.
•
Press button 3 (ALARM) again to deactivate the alarm.
The bell icon will disappear.
Snooze (silences alarm temporarily)
•
When alarm sounds, press button 4 (SNOOZE) to silence the alarm for 10
minutes. The snooze icon Zz and the alarm icon will flash.
•
In snooze mode, press any button to stop alarm for one day.
Note: The alarm is crescendo sound. The alarm will sound for 2 minutes and then shuts off
completely.