La Crosse C86234 Operation Manual - page 14

  P a g e

| 14  

STORM ALARM ON/ OFF SET: 

The storm warning display (flashing downward weather tendency arrow) can be accompanied 

by a ring of the alarm.  Switch the acoustic storm warning alarm On (AON) or Off (AOFF) 

(Default OFF).  

1.  The digit "AOFF" will flash. 

2.  Press the 

▲/DATE button or ▼/RAIN button to switch the alarm On or 

Off. ("AOFF" = Off; "AON" = On) 

3.  Press the SET button to confirm and to enter the WIND DIRECTION 

DISPLAY TYPE. 

WIND DIRECTION DISPL AY TYPE: 

The wind direction can be displayed using either compass directions or 

degree measurements.  N is equivalent to 0° on the compass. The 

default setting is compass directions.

1.  The wind direction will flash. 

2.  Press the 

▲/DATE button or ▼/RAIN button to toggle from 

compass directions to degree measurements. 

3.  The next steps in SET mode is the factory reset, so unless you 

wish to reset the display to factory defaults, simply wait until the 

SET mode times out and returns to the Mode 1 display. 

4.  If you wish to perform a FACTORY RESET, press the SET button to confirm and to 

enter the FACTORY RESET PROCEDURE. 

SEE WARNINGS

 in the FACTORY RESET 

section. 

FACTORY RESET PROCEDURE: 

WARNING:

Performing a factory reset will erase all MIN/MAX values and weather data stored in the 

display's internal memory and return the weather unit

’s settings back to the factory defaults.  If 

you have not yet uploaded the data to the Heavy Weather Pro software, the data will be lost. 

If you do not wish to reset the display to factory defaults, either: 

  Press the MIN/MAX button  or the ALARM button  to exit SET mode, or 

  Simply wait 30 seconds until the SET mode times out and returns to the Mode 1 display. 

To reset the display to the factory defaults, follow the procedure below. 

WARNING: 

A factory reset will erase the connection between the display and the thermo-hygro sensor and 

require the all sensor connections to be re-established.  

1.  "rES oFF" will flash. 

2.  Use the 

▲/DATE button or ▼/RAIN button to select "rES on". 

3.  Press the SET button to confirm and a countdown timer will begin counting down from 

"127" When the timer displays "dOnE", you must remove the batteries from the display 

for 10 minutes. While the batteries are out of the display, also remove the batteries from 

the thermo-hygro sensor and rain sensor.