La Crosse Technology C84428 Instruction Manual - Sensor Search | Sensor Id
Page | 11
Professional Remote Monitoring Station
Sensor Search | Sensor ID
Each of your sensors has an individual ID number on the bar code of the
sensor. This sensor ID is visible on your station by pressing the SENSOR
button.
View ID numbers:
• Press and release the SENSOR button to view individual station and
sensor ID numbers. All other information will disappear temporarily.
Search for all sensors:
• While viewing sensor ID, hold the SENSOR button for 3 seconds to
search for all sensors.
• The station will search for all sensor ID numbers on the station.
• The sensor reception icon will flash for each sensor while searching.
• Allow up to 3
minutes to receive sensor signal.
Sensor Update Interval
MPH
WIND SPEED
TOP
SPEED
1 HR
Sensor:
Change Required for Update
Updates:
No Change- Sensor Updates:
Rain
0.007 inch (0.2mm)
every 45 seconds
every 3 minutes
Wind
0.5 mph (0.8 km)
every 31.5 seconds
every 3 minutes
Temp/Humidity
0.9F (0.5 C)
every 50 seconds
every 3 minutes.
Example: It does not rain everyday. When it is not raining the rain sensor will update every 3 minutes. When it is raining , the rain
sensor will updated every 45 seconds.
Delete Sensor ID
OUTDOOR
In the rare event you need to replace your sensor, you will first need to
delete the old sensor ID from your station.
1. Press and release the SENSOR button to view your sensor ID number.
2. While viewing your sensor ID, hold the MINUS button for 5 seconds
to delete your old sensor ID. Dashes will show for the ID number.
3. Your station will search for a new sensor. Remove batteries from your
old sensor.
4. Install batteries in your new sensor and allow up to three minutes for
your new sensor readings and ID to appear on your station.
Note: When replacing your Thermo-hygro sensor, press the TX button
(under the battery cover) to send a signal immediately. The Rain and
Wind sensors do not have a TX button.
TX
C/F