La Crosse Technology S84060 Instruction Manual - page 19

Manual is about: PROFESSIONAL Remote Monitoring Weather Station

Page of 24

Download

Bookmark us

Page | 19

Professional Remote Monitoring Station

LTV-TH3 Thermo-Hygro Sensor

1. Install 2-AA batteries according to polarity and replace battery cover. The blue LED light will flash

when transmitting.

Mounting:

1. Use the hole at the top to hang your sensor from the back using a nail. Or, insert one mounting screw through

the front of your sensor.

2. Mount your sensor on a north-facing wall or in any shaded area. Under an eave or deck rail is preferred.

3. The maximum wireless transmission range to the weather station is up to 400 feet (121 meters) in open air,

not including walls or floors.

4. Be sure your sensor is mounted vertically, to allow moisture to drain out properly.

5. For online video instruction visit:

http://bit.ly/TH_SensorMounting

LED Light

Battery Cover

Hole for

mounting

F/C

∙ Press TX to send a signal

∙ Press F/C to select Fahrenheit

or Celsius display on sensor.

S84060 station:

1. Insert the power cord into a wall outlet, then into your station.

Optional: insert 3 AA batteries* into your station to maintain time/date in the event of a power outage.

*Battery operation only will not update sensor or Wi-Fi data. Power cord is required.

Mounting:

• Use the mounting holes on the back to place your station on a wall.

• Use the pull down stand on the back of your station to place on a desk or counter.

NOTE: You will want to place your station near an outlet, as the power cord is required for operation. Also, you will want

to mount or place this station within good Wi-Fi range of your wireless router. This will help when using all of the remote

monitoring options the La Crosse View™ app has to offer.

Optional

Batteries

Power

Cord