La Crosse Technology WS-1025 User Manual
1
WS-1025 Digital Window Thermometer
Features:
•
Clear functional design
•
Easy to read outdoor temperature from indoors
•
Maximum and minimum values with auto reset
•
Easy to mount
•
Detachable for simple window cleaning
•
Weather resistant
Specifications:
Measuring range:
-13 ºF to +158 ºF
Accuracy:
32 ºF to 122 ºF ± 1.8 ºF, otherwise ± 2.7 ºF
Resolution:
0.1 ºF (0.1ºC)
Battery:
1
AAA
alkaline
Installation:
1.
Select your location for mounting in an area that is easy to view.
2.
Clean the glass surface completely before mounting.
NOTE: Be sure to completely clean the surface of dust and dirt and let the area dry completely prior to mounting the thermometer. Failure to do so may result in bad
adhesion between the window and holder.
3.
Remove the holder that has the adhesive tape attached (this is held on by a pressure fitting and can simply be pulled off).
4.
Using a screwdriver open the battery compartment.
5.
Remove the plastic tab from between the battery and the positive terminal.
6.
At this point the display will be active.
7.
Replace the battery compartment door.
8.
Replace the thermometer into the holder.
9.
Remove the protective film from the display of the thermometer.
NOTE: Before continuing please be sure to set the time – See the next section on Setting the Time
10. Remove the plastic from the adhesive strip.
11. Press the adhesive strip against the glass to adhere the thermometer.
Please note: In order to obtain the most accurate temperature reading be sure to mount the thermometer out of direct sunlight. Mounting the unit in direct sunlight
will cause artificially high temperature readings.
Setting the Time:
1.
Press the MODE button to enter the setting mode.
2.
The hours digits will flash in the center of the display.
3.
Press and release the + button to advance the hour.
NOTE: When in the hours between midnight and noon A.M. will be displayed on the left of the display. When in the hours between noon and midnight P.M. will be
displayed on the left side of the display.
4.
Press and release the MODE button to confirm the hour and advance to the minute setting.
5.
The minutes digits will flash at the bottom of the display.
6.
Press and release the + button to advance the minute.
7.
Holding down the + button will advance the minutes faster.
8.
Press and release the MODE button to confirm the minutes and exit the time setting mode.
NOTE: The thermometer does not have an automatic time out feature and will stay in the time set mode until manually completed.
Use and MAX/MIN temperatures:
•
The upper display shows the maximum temperature.
•
The middle display shows the current temperature.
•
The lower display shows the minimum temperature.
•
The maximum temperature automatically resets at 8:00 A.M.
•
The minimum temperature automatically resets at 8:00 P.M.
•
If the time is not set the maximum and minimum temperature will not be reset at the correct local time.
Maintenance:
•
Replace the battery when the display becomes weak.
•
Do not expose the instrument to extreme temperatures, vibration or shock
•
Clean the thermometer with a soft damp cloth only. Do not use solvents or scouring agents.
•
Please do not try to repair the unit. Contact the original point of purchase or La Crosse Technology Warranty for repair/replacement instructions.