La Crosse Technology WS-2510 Commissioning Instructions

Short-form instructions for commissioning the

Wireless Weather Station WS 2510

A functional test of the complete weather station should be carried out before the individual sensors are fitted in their final

location. For this purpose, it is practical to set up all the sensors near to the base station, although, in doing so, a minimum

distance of 6 feet must be maintained.

Step 1

Commissioning the wireless temperature/humidity sensor by inserting

a round bar magnet into the opening in the housing.

Step 2

Activating the wireless wind sensor by inserting the associated round bar

magnet.

Step 3

To commission the wireless rain sensor, the housing must first be opened.

The housing is placed on a flat surface with the funnel opening downwards.

Turning the base plate in a clockwise direction will unlock it and enable it 

to be removed.

Step 4

The round bar magnet for commissioning the wireless rain sensor must 

be pushed into the latching holder on the electronic box (located in the top 

half of the now seperated rain sensor).  The correct polarity is marked in 

red on the latching holder.  The housing is closed by aligning the top and 

bottom half so that the magnet on the rocker is facing the electronic

box.  Locking is achieved by turning the base plate in a counter-clockwise

direction until it clicks into place.