1. DL manuals
  2. La Crosse Technology
  3. Clock
  4. WS-6002U
  5. Instruction Manual

La Crosse Technology WS-6002U Instruction Manual

Manual is about: La Crosse Technology Instruction Manual Atomic Clock WS-6002U

Summary of WS-6002U

  • Page 1

    Ws-6002u atomic clock instruction manual.

  • Page 2

    2 table of contents topic page inventory of contents/ additional equipment 3 about wwvb 3 quick set-up guide 4 detailed set-up guide battery installation 5 program mode function buttons 6 time zone setting 7 dst (daylight saving time) setting 7-8 language selection 8 time setting 8 calendar setting ...

  • Page 3

    3 inventory of contents 1) ws-6002u 2) instruction manual and warranty card. Additional equipment (not included) 1) two fresh 1.5v aa batteries. 2) three wall-hanging screws. 3) appropriate screwdriver for screws. About wwvb (radio controlled time) the nist (national institute of standards and techn...

  • Page 4

    4 quick set-up guide 1) insert two aa batteries into the atomic clock. 2) wait 15 minutes for wwvb reception. 3) if there is no wwvb reception, manually set the time and date (instructions in the program mode). 4) program the settings. 5) mount the ws-6002u in a suitable location, where wwvb signals...

  • Page 5

    Detailed set-up guide set i) battery installation note: to avoid start-up problems make sure that the batteries do not spring free. Battery compartment battery cover a) atomic clock 1) remove the battery cover, located on the backside of the function buttons. 2) observe the correct polarity, and ins...

  • Page 6

    Search after 10 minutes if the time is not found. When the search is cancelled “-:--”will appear in the time lcd. The atomic clock will conduct a wwvb search every hour until the first signal is found. Once the wwvb time is found, a search is automatically conducted nightly at midnight. If the signa...

  • Page 7

    7 ii) time zone setting 1) hold down the “set” button for 2 seconds, the default setting “-5est” will flash in the date lcd. 2) press and release the “+” button to select the appropriate time zone. There are 13 time zones to choose from: -5est eastern time (default setting) -6cst central time -7mst ...

  • Page 8

    8 2) press and release the “+” button to turn the dst off, as will be indicated by the display of “off” in the time lcd. 3) press and release the “set” button to confirm the dst setting, and to advance to select the language for the weekday. Iv) language selection for the weekday 1) hold down the “s...

  • Page 9

    9 vi) calendar setting note: when the wwvb signal is found, that date will over-ride the manually set date. 1) hold down the “set” button for 2 seconds (the selected time zone will flash), press the “set” button 5 more times, until the default year “00” flashes in the date lcd. 2) press and release ...

  • Page 10

    10 viii) selecting °f or °c 1) hold down the “set” button for 2 seconds (the selected time zone will flash), press the “set” button 10 more times, until the default “ °f” flashes in the time lcd. 2) press and release the “+” button to toggle between °f and °c. 3) press and release the “set” button t...

  • Page 11

    Mounting 11 there are two possible ways to mount the atomic clock: set hanging holes function buttons foldout table stand • use of the foldout table stand, or • wall mounting. I) foldout table stand the foldout table stand leg is located on the backside of the atomic clock. The hinge is towards the ...

  • Page 12

    1) using a straightedge, horizontally space at 3-15/16 of an inch (100.58mm) three screw positions on a wall. 2) install three mounting screws (not included) into a wall within transmission range—leaving approximately 3/16 of an inch (5mm) extended from the wall. 3) place the atomic clock onto the s...

  • Page 13

    13 computers, or other radio controlled clocks. 4) remove batteries for five minutes, reinsert and leave the unit alone overnight without pressing buttons. 5) if problems persist contact la crosse technology. Problem: hour is incorrect (minute and date are correct). Solution: 1) be sure correct time...

  • Page 14

    14 warranty information la crosse technology, ltd provides a 1-year limited warranty on this product against manufacturing defects in materials and workmanship. This limited warranty begins on the original date of purchase, is valid only on products purchased and used in north america and only to th...

  • Page 15

    15 for warranty work, technical support, or information contact: la crosse technology, ltd 190 main street la crescent, mn 55947 phone: 507.895.7095 fax: 507.895.2820 e-mail: support@lacrossetechnology.Com (warranty work) sales@lacrossetechnology.Com (information on other products) web: www.Lacrosse...