La Crosse Technology WS-6020U-IT Instruction Manual - page 2
WS-6020U-IT www.lacrossetechnology.com/support
Page | 2
Setup with Standard Alkaline Batteries
1.
Insert the 2 "AA" Alkaline batteries (not included) into the solar
station. Observe the correct polarity.
2.
Gently press the RESET button on the Sensor to activate.
3.
After 5 minutes place sensor outside in a shaded location.
MIN/MAX Readings
View: Press the MIN/MAX button to view:
•
Outdoor Temperature minimum and maximum.
•
Indoor temperature minimum and maximum.
Reset MIN/MAX: Hold the MIN/MAX button for 5 seconds to reset
the indoor and outdoor minimum and maximum temperatures to
current temperatures.
Position Outdoor Sensor
•
It is important to place the sensor in a bright environment for the
solar panel to collect enough light to recharge the internal power
cell.
WARNING:
Do NOT recharge the
Solar-rechargeable batteries
(included) outside of this product
because it will damage the batteries
and other charging devices.
SWITCH UP
(SOLAR-RECHARGEABLE BATTERIES)
Slide the battery switch to UP position once
solar-rechargeable batteries are inserted.
SWITCH DOWN
(START-UP / RESET) (STANDARD ALKALINES)
Slide switch to DOWN position before
(1) start-up / reset or (2) any type of battery replacement