1. DL manuals
  2. La Crosse Technology
  3. Weather Station
  4. WS-7025U
  5. Instruction Manual

La Crosse Technology WS-7025U Instruction Manual

Other manuals for WS-7025U: Instruction Manual
Manual is about: Wireless 433 MHz Radio-controlled Weather Station

Summary of WS-7025U

  • Page 1

    Ws-7025u wireless 433 mhz radio-controlled weather station instruction manual.

  • Page 2

    2.

  • Page 3: Topic Page

    3 topic page inventory of contents/additional equipment 4 about wwvb 4-5 quick set-up guide 5 detailed set-up guide battery installation 5-6 program mode function keys 7 12/24 hour time setting 7 time zone setting 7-8 daylight saving time setting 8 time setting (wwvb & manual) 9-10 setting day, date...

  • Page 4

    4 inventory of contents 1. The weather station (figure 1). 2. One tx3u remote control sender with mounting bracket (figure 2). 3. Three each, ½” philips screws. 4. One strip double-sided adhesive tape. 5. Instruction manual and warranty card. Additional equipment (not included) 1. Two fresh aa 1.5v ...

  • Page 5

    5 continually measuring every second, of every day, to an accuracy of ten billionths of a second per day. These physicists have created an international standard measuring a second as 9,192,631,770 vibrations of a cesium-133 atom in a vacuum. Quick set-up guide 1. Insert two aaa batteries into the r...

  • Page 6

    6 to fall away from the unit. Place the screw partially back into its hole and angle it slightly—so the threads grab the battery cover. With the screw, pull the battery cover off. 3. Observing the correct polarity install 2 aaa batteries. The batteries will fit tightly (to avoid start-up problems ma...

  • Page 7

    7 program mode programming note: if 30 seconds are allowed to pass or either the in or the out button is pressed during programming modes, the unit will set the last information entered—the display will stop flashing and return to normal time-date readings. If you don’t leave the program mode during...

  • Page 8

    8 the top of the time lcd. Observe the chart below, showing the corresponding abbreviations, time zones, and codes. Time zones gmt 0 atlantic -4 est; eastern -5 cst; central -6 mst; mountain -7 pst; pacific -8 ala; alaska -9 haw; hawaii -10 note: there are more time zones represented by numbers than...

  • Page 9

    9 v. Time there are two methods by which the time can be set: a) automatically via wwvb reception or b) manually. A. Wwvb (remote control time) this method requires you to do nothing except wait for the signal to be received and to select a time zone. Reception usually takes approximately 6-10 minut...

  • Page 10

    10 6. Press the set button to confirm the minutes and to advance to the day, date, and year setting mode. Note: in 12h mode, “pm” will appear to the left of the time during pm hours. If the time is not within the pm hours, nothing will be displayed. Be sure to set the time to the correct am/pm time ...

  • Page 11

    11 10. Press the set button to confirm and to advance to the °f or °c setting mode. Vii. Selecting °f or °c 1. Press and hold the set button for 3 seconds, or until “12h” or “24h” flashes in the date lcd. 2. Press the set button 9 times to reach the °f or °c setting mode. 3. “ °f” is the default set...

  • Page 12

    12 features of the ws-7025u i. Back light the ws-7026u has a backlight that can be activated by pressing any of the eight function buttons. After a button has been pressed the backlight will come on for five seconds before automatically shutting off. Ii. Weather forecast the weather forecasting feat...

  • Page 13

    13 a. Weather icons there are 3 possible weather icons that will be displayed in the forecast lcd: sunny—indicates that the weather is expected to improve (not that the weather will be sunny). Sun with clouds—indicates that the weather is expected to be fair (not that the weather will be sunny with ...

  • Page 14

    14 iii. Indoor temperature, humidity, and comfort level indicator the current indoor temperature (viewed on the left) and relative humidity (viewed on the right) are displayed in the indoor lcd. The comfort level indicator is located at the center of the indoor lcd. The indicator will display a happ...

  • Page 15

    15 3. While “max” is still displayed press the in button again to return to the current data display. By waiting 20 seconds during either the minimum or the maximum readings the unit will automatically return to current data readings. B. Viewing the outdoor temperature records 1. Press the out butto...

  • Page 16

    16 1. Press and hold the al1 button for 5 seconds or until the alarm-time display flashes in the date lcd. 2. Press the in button to set the alarm hours and the out button to set the alarm minutes. 3. Press the al1 button or wait 15 seconds for the unit to automatically confirm the alarm time and re...

  • Page 17

    17 up of remote control sender units with the ws-7025u. These extra sensors can be purchased through the same dealer as this unit, or by contacting la crosse technology directly. A tx3u will monitor temperature only and the tx3up will monitor the temperature via a probe for use in pools, spas, etc. ...

  • Page 18

    18 the button twice) will display the same data for the maximum recordings. 3. To reset the minimum/maximum readings, it is necessary to select which remote control sender you wish to reset. Press and hold the out button for 5 seconds, the records for the selected remote control sender unit will be ...

  • Page 19

    19 mounting note: before permanently mounting ensure that the indoor temperature station is able to receive wwvb signals from the desired location. Also, extreme and sudden changes in temperature will decrease the accuracy of the weather station and changes in elevation will result with inaccurate w...

  • Page 20

    20 1) with a nonabrasive solution, clean and dry the back of the mounting bracket and the mounting surface to ensure a secure hold. The mounting surface should be smooth and flat. 2) remove the protective strip from one side of the tape. Adhere the tape to the designated area on the back of the moun...

  • Page 21

    21 troubleshooting problem: no reception of wwvb time signal. Solution: 1) wait overnight for signal. 2) be sure weather station is at least 6 feet from any electrical devices such as televisions, computers or other radio-controlled clocks. 3) remove batteries for five minutes, reinsert and leave th...

  • Page 22

    22 maintenance and care instructions • extreme temperatures, vibration and shock should be avoided to prevent damage to the units. • clean displays and units with a soft, damp cloth. Do not use solvents or scouring agents. They may mark the displays and casings. • do not submerge in water. • immedia...

  • Page 23

    23 specifications temperature measuring range: indoor: 32 °f to 139.8°f with 0.2°f resolution. (0 °c to 59.9°c with 0.1 °c resolution) “ofl” displayed if outside this range outdoor: -21.8 °f to 157.2°f with 0.2°f resolution. (-29.9 °c to 69.9°c resolution) “ofl” displayed if outside this range indoo...

  • Page 24

    24 warranty information la crosse technology, ltd provides a 1-year limited warranty on this product against manufacturing defects in materials and workmanship. This limited warranty begins on the original date of purchase, is valid only on products purchased and used in north america and only to th...

  • Page 25

    25 public information. This product is not a toy. Keep out of children’s reach. This warranty gives you specific legal rights. You may also have other rights specific to your state. Some states do no allow the exclusion of consequential or incidental damages therefore the above exclusion of limitati...