- DL manuals
- La Crosse Technology
- Weather Station
- WS-7075U
- Instruction Manual
La Crosse Technology WS-7075U Instruction Manual - page 20
20
MAINTENANCE AND CARE INSTRUCTIONS
• Extreme temperatures, vibration, and shock should be avoided to prevent
damage to the units.
• Clean displays and units with a soft, damp cloth. Do not use solvents or
scouring agents; they may mark the displays and casings.
• Do not submerge in water.
• Immediately remove all low powered batteries to avoid leakage and
damage.
• Opening the casings invalidates the warranty. Do not try to repair the unit.
Contact La Crosse Technology for repairs.
Summary of WS-7075U
Page 1
Ws-7075u wireless 433 mhz radio-controlled weather station instruction manual.
Page 2: Topic Page
2 table of contents topic page inventory of contents/additional equipment 3 about wwvb 3-4 quick set-up guide 4 detailed set-up guide battery installation 4-5 program mode function keys 6 12/24 hour time setting 6 time zone setting 6-7 daylight saving time setting 7 time setting (wwvb & manual) 8-9 ...
Page 3
3 inventory of contents 1. The weather station (figure 1). 2. One tx3u remote control sender with mounting bracket (figure 2). 3. Three each, ½” philips screws. 4. One strip double-sided adhesive tape. 5. Instruction manual and warranty card. Additional equipment (not included) 1. Two, fresh aa 1.5v...
Page 4
4 a second per day. These physicists have created an international standard, measuring a second as 9,192,631,770 vibrations of a cesium-133 atom in a vacuum. Quick set-up guide 1. Insert two aaa batteries into the remote control sender. 2. Insert two aa batteries into the weather station. 3. Wait 5 ...
Page 5
5 back into its hole, and angle it slightly—so the threads grab the battery cover. With the screw, pull the battery cover off. 3. Observing the correct polarity install 2 aaa batteries. The batteries will fit tightly (to avoid start-up problems make sure they do not spring free). 4. Check the lcd sc...
Page 6
6 program mode programming note: if 30 seconds is allowed to pass, or either the in or the out buttons are pressed during programming modes the unit will confirm/set the last information entered—the display will stop flashing and return to normal time-date readings. If you don’t leave the program mo...
Page 7
7 2. Press the set button 1 more time to enter the time zone setting mode. The default time zone “-5” will flash in the date lcd. 3. Select your appropriate time zone using the ch button. During selection of the time zone, the 3 letter abbreviations for the time zones found in north america will fla...
Page 8
8 note: some locations (arizona and parts of indiana) do not follow daylight saving time, and should select “dst 0.” 5. Press the set button to confirm and advance to the time setting mode. V. Time there are two methods by which the time can be set: a) automatically via wwvb reception, or b) manuall...
Page 9
9 4. Press the set button to confirm the hour setting, and to advance to the minute setting mode. 5. The minute digits should be flashing. Press the ch button to change the minutes—increasing the minutes by increments of 1 with each press of the ch button. 6. Press the set button to confirm the minu...
Page 10
10 8. Press the set button to confirm and to enter the year setting mode. 9. The default-year will be flashing, use the ch to set the appropriate year. 10. Press the set button to confirm and to advance to the °f or °c setting mode. Vii. Selecting °f or °c 1. Press and hold the set button for 3 seco...
Page 11
11 features of the ws-7075u i. Weather forecast the weather forecasting feature is estimated to be 75% accurate. The weather forecast is based solely upon the change of air pressure over time. The ws-7075u averages past air-pressure readings to provide an accurate forecast—creating a necessity to di...
Page 12
12 sunny—indicates that the weather is expected to improve (not that the weather will be sunny). Sun with clouds—indicates that the weather is expected to be fair (not that the weather will be sunny with clouds). Clouds with rain—indicates that the weather is expected to get worse (not that the weat...
Page 13
13 iii. Outdoor temperature the outdoor temperature is viewed in the outdoor lcd. When there is more than one remote control sender unit in operation, a “boxed” number will appear to the right of the temperature. This indicates which remote control sender unit (1, 2, or 3) is currently displaying it...
Page 14
14 occurrence are displayed. The minimum records will display for 20 seconds. 2. Press the out button again (once while “min” is still displayed, twice otherwise). “max” appears in the upper- center location of the flashing outdoor lcd, indicating that the maximum temperature and the time and date o...
Page 15
15 press the al1 button (removing the ((1)) icon from the screen). To reactivate the alarm, press the al1 button again. 6. After each activation or deactivation, the programmed alarm time is displayed. Wait 15 seconds and the date will display in the date lcd again. 7. To set, activate, and deactiva...
Page 16
16 arise if this is not done correctly and if the total time for set-up exceeds 6 minutes. A. Set-up of multiple units 1. It is necessary to remove the batteries from all units currently in operation. 2. Remove the battery covers to all remote control sender units. 3. Place all remote control sender...
Page 17
17 mounting note: before permanently mounting ensure that the indoor temperature station is able to receive wwvb signals from the desired location. Also, extreme and sudden changes in temperature will decrease the accuracy of the weather station, and changes in elevation will result with inaccurate ...
Page 18
18 ensure a secure hold. The mounting surface should be smooth and flat. 2) remove the protective strip from one side of the tape. Adhere the tape to the designated area on the back of the mounting bracket. 3) remove the protective strip from the other side of the tape. Position the remote control s...
Page 19
19 troubleshooting problem: no reception of wwvb time signal. Solution: 1) wait overnight for signal. 2) be sure weather station is at least 6 feet from any electrical devices, such as televisions, computers, or other radio-controlled clocks. 3) remove batteries for five minutes, reinsert and leave ...
Page 20
20 maintenance and care instructions • extreme temperatures, vibration, and shock should be avoided to prevent damage to the units. • clean displays and units with a soft, damp cloth. Do not use solvents or scouring agents; they may mark the displays and casings. • do not submerge in water. • immedi...
Page 21
21 specifications temperature measuring range: indoor: 32 °f to 139.8°f with 0.2°f resolution. (0 °c to 59.9°c with 0.1 °c resolution). “ofl” displayed if outside this range. Outdoor: -21.8 °f to 157.2°f with 0.2°f resolution. (-29.9 °c to 69.9°c resolution). “ofl” displayed if outside this range. I...
Page 22
22 warranty information la crosse technology, ltd provides a 1-year limited warranty on this product against manufacturing defects in materials and workmanship. This limited warranty begins on the original date of purchase, is valid only on products purchased and used in north america and only to th...
Page 23
23 public information. This product is not a toy. Keep out of children’s reach. This warranty gives you specific legal rights. You may also have other rights specific to your state. Some states do no allow the exclusion of consequential or incidental damages therefore the above exclusion of limitati...