- DL manuals
- La Crosse Technology
- Weather Station
- WS-7220U-IT
- Instruction Manua
La Crosse Technology WS-7220U-IT Instruction Manua
Summary of WS-7220U-IT
Page 1
1 ws-7220u-it 915 mhz wireless weather station instruction manual.
Page 2
2 table of contents introduction……………………………………………………………………………………..3 inventory of contents…………………………………………………………………………4 quick set up……………………………………………………………………………………4 detailed set up………………………………………………………………………………4-5 battery installation…………..………………………………………………………..4-5 12 or 24 hour time display………..……...
Page 3: Figure 1
3 figure 1 instant transmission is the state-of- the-art new wireless transmission technology, exclusively designed and developed by la crosse technology. Instant transmission offers you an immediate update (every 4 seconds!) of all your outdoor data measured from the transmitters: follow your clima...
Page 4: Figure 2
4 inventory of contents 1. Wireless weather station (figure 1) 2. Wireless thermo-hygro sensor (tx29uth-it) and mounting bracket. (figure 2) 3. 3 each, 1/2” philips screws. 4. One strip of double sided adhesive tape. 5. Instruction manual and warranty card. Additional equipment (not included) 1. 1 p...
Page 5
5 feet of resistance and an interior wall will have up to 10 feet of resistance. Your distance plus resistance should not exceed 330 feet in a straight line. Note: fog and mist will not harm your thermo-hygro sensor, but direct rain must be avoided. Detailed setup guide i. Battery installation (when...
Page 6
6 * when the signal is successfully received by the weather station, the icon will be switched on. (if not successful, the icon will not be shown in lcd) so the user can easily see whether the last reception was successful (icon on) or not (icon off). On the other hand, the short blinking of the ico...
Page 7
7 ii. Features a. Minimum and maximum temperatures and humidity 1. Press and release the min/max button, “min” appears at the bottom of the lcd and the recorded minimum temperatures and humidity are displayed. 2. Press and release the min/max button again to view maximum recorded temperatures and hu...
Page 8
8 note: you must insert the batteries into the third sensor within 30 seconds of reception of the second sensor. Important: transmission problems will arise if the setting for multiple sensors is not followed as described above. Should transmission problems occur, it is necessary to remove the batte...
Page 9
9 b. Mounting with adhesive tape note: the adhesive tape is not intended to be used as a permanent mounting solution. Only use the adhesive tape while you are positioning the weather station and thermo-hygro sensor. 1) with a nonabrasive solution, clean and dry the back of the mounting bracket and t...
Page 10
10 5) taking care not to press any buttons, reinstall the batteries in the wireless weather station according to the diagram in the battery compartment. 6) do not press any buttons for at least 15 minutes after installing the batteries. (this is to let the units establish a good connection.) 7) duri...
Page 11
11 thermo-hygro sensor 5.05” x 1.5” x 0.83” (128.3 x 38.2 x 21.2mm) battery life up to 24 months warranty information la crosse technology, ltd provides a 1-year limited warranty on this product against manufacturing defects in materials and workmanship. This limited warranty begins on the original ...
Page 12
12 based on misrepresentation by the seller or performance variations resulting from installation-related circumstances. La crosse technology, ltd will not assume liability for incidental, consequential, punitive, or other similar damages associated with the operation or malfunction of this product....
Page 13
13 fcc id: omotx29uth (transmitter) rf exposure mobile: the internal / external antennas used for this mobile transmitter must provide a separation distance of at least 20 cm (8 inches) from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter." st...