Ws-8007u radio controlled moon phase clock instruction manual.
2 table of contents topic page inventory of contents/ additional equipment 3 about wwvb 3 quick set-up guide 3 detailed set-up guide battery installation 4 program mode function buttons 5 time zone setting 5 dst (daylight saving time) setting 6 language selection 6 time setting 6 calendar setting 7 ...
3 inventory of contents 1) ws-8007u 2) instruction manual and warranty card. Additional equipment (not included) 1) two fresh 1.5v aa batteries. 2) three wall-hanging screws. 3) appropriate screwdriver for screws. About wwvb (radio controlled time) the nist (national institute of standards and techn...
4 a) moon phase clock 1) remove the battery cover, located on the backside of the moon phase clock and directly below the function buttons. 2) observe the correct polarity, and install 2 aa batteries. 3) replace the battery cover. Note: after the batteries have been installed a tone will sound, and ...
5 your clock will automatically set up with eastern time zone, daylight saving time on, english for the language, 12 hour clock (am/pm) and °f for temperature. I) function buttons there are 4 function buttons located on the backside of the moon phase clock. The function buttons are labeled: “set”, “...
6 iv) language selection for the weekday 1) the default language “us” will be flashing in the time lcd. 2) press and release the “+” button to select the desired language. There are 3 languages to select from: us english f french e spanish 3) press and release the “set” button to confirm the languag...
7 9) press and release the “set” button to confirm the date and to set the weekday. 10) the default weekday “mon” (depends on selected language) will flash. 11) press and release the “+” button to select the appropriate weekday. 12) press and release the “set” button to confirm the calendar settings...
8 2) press and release the “+” button to set the alarm hour. 3) press and release the “alm” button to confirm the hour and to move to set the alarm minutes. 4) the alarm minutes flash. 5) press and release the “+” button to set the alarm minutes. 6) press and release the “alm” button to confirm and ...
9 iv) indoor temperature the indoor temperature appears on the right side of the date lcd. The temperature is checked every 10 seconds, and updated whenever there is a change. Mounting there are two possible ways to mount the moon phase clock: use of the foldout table stands, or • wall mounting. I) ...
10 ii) wall mounting 1) using a straightedge, horizontally space at 3- 15/16 of an inch (100.58mm) three screw positions on a wall. 2) install three mounting screws (not included) into a wall within transmission range—leaving approximately 3/16 of an inch (5mm) extended from the wall. 3) place the m...
11 2) check batteries. 3) contact la crosse technology. Note: for any questions not answered, contact la crosse technology with the contact information found at the end of this instructional manual. Specifications temperature: measuring range: 32 °f to 122°f with 0.2°f resolution (0 °c to 50°c with ...
12 for warranty work, technical support, or information contact: la crosse technology, ltd 2809 losey blvd. S. La crosse, wi 54601 phone: 608.782.1610 fax: 608.796.1020 e-mail: support@lacrossetechnology.Com (warranty work) sales@lacrossetechnology.Com (information on other products) web: www.Lacros...
