La Crosse Technology WS-8115U-IT Instruction Manual - Deactivate/activate Alarm
WS-8115U-IT www.lacrossetechnology.com/support
Page | 3
Low
Battery
Icons
Deactivate/Activate Alarm
Press
ALARM
once, firmly, to deactivate the alarm.
The alarm icon will disappear.
Press
ALARM
once, firmly, to activate the alarm.
The alarm icon will appear.
Snooze
Press SNOOZE to silence an active alarm for 10 minutes.
The alarm icon will flash.
This is a crescendo alarm that will sound for 85 seconds if not
deactivated. Press any button to stop the alarm for 24 hours.
Reset Button
If the atomic clock display appears distorted or is not
responding to buttons, use a pen or paperclip to press
RESET
one time.
This will reset the atomic to default settings.
WWVB Radio-controlled Time
WWVB Icon will flash when searching.
For information about WWVB visit:
www.nist.gov/pml/div688/grp40/wwvb.cfm
ATOMIC SIGNAL SEARCH:
The atomic clock will search for 1 hour between midnight and 6am until
the WWVB time signal is received. After reception, the atomic clock will
only search for the atomic signal after midnight.
Low Battery Icon
Low battery icon indicates low battery for station or sensor.
When the TX icon is displayed replace batteries in the outdoor
sensor.
When the RX icon is displayed replace batteries in the atomic clock.
WWVB
Atomic Icon
Alarm
Icon
SNOOZE