1. DL manuals
  2. La Crosse Technology
  3. Weather Station
  4. WS-9055TWC
  5. Instruction Manual

La Crosse Technology WS-9055TWC Instruction Manual

Manual is about: Wireless 433 MHz Weather Station

Summary of WS-9055TWC

  • Page 1

    Ws-9055u wireless 433 mhz weather station instruction manual.

  • Page 2

    2 table of contents topic page quick setup 3-5 inventory of contents 6-7 detailed setup guide battery installation 7 setting the time 8 features minimum and maximum temperatures 9 resetting minimum and maximum temperatures 10 adding additional remote temperature sensors (optional) 10-11 weather fore...

  • Page 3

    3 quick setup hint: use good quality alkaline batteries and avoid rechargeable batteries. 1. Have the indoor temperature station and remote temperature sensor 3 to 5 feet apart. 2. Batteries should be out of both units for 10 minutes. 3. Place the batteries into the remote temperature sensor first t...

  • Page 4

    4 in this time the indoor temperature station and remote temperature sensor will start to talk to each other and the display will show both the indoor temperature and an outdoor temperature. If the indoor temperature station does not display both temperatures after the 15 minutes please retry the se...

  • Page 5

    5 resistance. Your distance plus resistance should not exceed 80 ft. In a straight line. Note: fog and mist will not harm your remote temperature sensor but direct rain must be avoided. To complete the set up of your indoor temperature station after the 15 minutes have passed please follow the steps...

  • Page 6

    Inventory of contents 1. The indoor weather station (figure 1) 2. The remote temperature sensor (tx6u) and mounting bracket. (figure 2) 3. 3 each, 1/2” philips screws. 4. One strip of double sided adhesive tape. 5. Instruction manual and warranty card. Figure 2 figure 1 holder 6.

  • Page 7

    Additional equipment (not included) 1. 1 philips screwdriver. 2. 2 fresh aa alkaline batteries. 3. 2 fresh aa alkaline batteries detailed setup guide battery installation 1. Install 2 aa batteries in the remote temperature sensor. Make sure they do not spring free, or start-up problems may occur. 2....

  • Page 8

    Setting the time 1. Press and hold the “set” key for 4 seconds. 2. The hour will flash. 3. Press and release the “+” key to advance the hour. 4. Press and release the “set” key. 5. The minute is flashing. 6. Press and release the “+” key to advance the minutes. 7. Press and release the “set” key to ...

  • Page 9

    9 features minimum and maximum temperatures 1. Press and release the “min/max” button, “max” appears between the indoor and remote temperatures. 2. The recorded maximum indoor and remote temperature is displayed. 3. Press and release the “min/max” button. 4. “min” appears between the indoor and remo...

  • Page 10

    10 resetting min and max temperatures to reset both the minimum and maximum temperatures—press and hold the “min/max” button for 5 seconds. Adding additional remote temperature sensors (optional) the ws-9055u is able to receive signals from 3 different remote temperature sensors. Following are some ...

  • Page 11

    11 when setting up multiple remote temperature sensors, it is important to remove the batteries from all existing units in operation, then to insert batteries first into all the remote temperature sensors. Second install batteries into the indoor weather station and do not press any buttons for ten ...

  • Page 12

    12 weather forecast the weather forecasting feature is estimated to be 75% accurate. The weather forecast is based solely upon the change of air pressure over time. The ws-9055u averages past air- pressure readings to provide an accurate forecast, creating a necessity to disregard all weather foreca...

  • Page 13

    Weather icons there are 3 possible weather icons that will be displayed in the forecast lcd: sunny—indicates that the weather is expected to improve (not that the weather will be sunny). Sun with clouds— indicates that the weather is expected to be fair (not that the weather will be sunny with cloud...

  • Page 14

    14 the weather icons change when the unit detects a change in air pressure. The icons change in order, from “sunny” to “partly sunny” to “cloudy” or the reverse. It will not change from “sunny” directly to “rainy”, although it is possible for the change to occur quickly. If the symbols do not change...

  • Page 15

    15 mounting note: to achieve a true temperature reading, avoid mounting in direct sunlight. We recommend that you mount the remote temperature sensor on a north-facing wall. The sending range is 80ft; obstacles such as walls, concrete, and large metal objects will reduce the range. Place both units ...

  • Page 16

    16 use the table-stand all that is required is to place the indoor weather station in an appropriate location. To wall mount the indoor weather station first remove the table stand. Next insert an appropriate screw in your desired location. Using the integrated hanging hole on the back of the unit, ...

  • Page 17

    17 1. Remove all batteries, reinsert into remote temperature sensor first, then into the indoor weather station. 2. Place remote temperature sensor closer to the indoor weather station. 3. Be sure all batteries are fresh. 4. Place remote temperature sensor and indoor weather station in position so t...

  • Page 18

    18 case or radiant heat). Also, the much greater range of the outdoor temperature sensor requires a different calibration curve than the indoor range. Error is usually greater at the extreme ends of a range, making it harder to compare different ranges with different curves. Under non-laboratory con...

  • Page 19

    19 • opening the casings invalidates the warranty. Do not try to repair the unit. Contact la crosse technology repairs. Specifications transmitting frequency 433mhz measuring temperatures indoor weather station 32 °f to 156.2°f with 0.2 °f resolution (0 °c to 69.0°c with 0.1 °c resolution) remote te...

  • Page 20

    20 batteries—(alkaline recommended) remote temperature sensor 2 x aa, 1.5v indoor weather station 2 x aa, 1.5v dimensions: (l x w x h) indoor weather station 5.5” x 3.2” x 1.25” (140 x 81 x 32 mm) remote temperature sensor 1.57 x 0.85 x 5.00 in. (128 x 40 x 23 mm) battery life approximately 1 year.

  • Page 21

    21 warranty information la crosse technology, ltd provides a 1-year limited warranty on this product against manufacturing defects in materials and workmanship. This limited warranty begins on the original date of purchase, is valid only on products purchased and used in north america and only to th...

  • Page 22

    22 specified above. All replaced parts and products become the property of la crosse technology, ltd and must be returned to la crosse technology, ltd. Replacement parts and products assume the remaining original warranty, or ninety (90) days, whichever is longer. La crosse technology, ltd will pay ...

  • Page 23

    23 the carrier); (3) damage to, or deterioration of, any accessory or decorative surface; (4) damage resulting from failure to follow instructions contained in your owner’s manual; (5) damage resulting from the performance of repairs or alterations by someone other than an authorized la crosse techn...

  • Page 24

    24 product. This product is not to be used for medical purposes or for public information. This product is not a toy. Keep out of children’s reach. This warranty gives you specific legal rights. You may also have other rights specific to your state. Some states do no allow the exclusion of consequen...

  • Page 25

    25 for warranty work, technical support, or information contact: la crosse technology, ltd 190 main street la crescent, mn 55947 phone: 507.895.7095 fax: 507.895.2820 e-mail: support@lacrossetechnology.Com (warranty work) sales@lacrossetechnology.Com (information on other products) web: www.Lacrosse...

  • Page 26

    26 fcc disclaimer this device complies with part 15 of the fcc rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference. (2) this device must accept any interference received, including interference that may cause undesired operation. All rights...