1. DL manuals
  2. La Crosse Technology
  3. Weather Station
  4. WS-9057U
  5. Instruction Manual

La Crosse Technology WS-9057U Instruction Manual

Summary of WS-9057U

  • Page 1

    1 weather station model ws-9057u instruction manual instant transmission is the state-of- the-art new wireless transmission technology, exclusively designed and developed by la crosse technology. Instant transmission offers you an immediate update (every 4 seconds!) of all your outdoor data measured...

  • Page 2

    5 setup when one transmitter is used 1. First, insert the batteries in the transmitter (see “how to install and replace batteries in the thermo-hygro outdoor transmitter ”on page 11). 2. Within 2 minutes of powering up the transmitter, insert the batteries in the weather station (see “how to install...

  • Page 3

    9 when the weather station is receiving the wwvb time signal, the outdoor transmitter data signal will temporarily not be received by the weather station. During this short period of time, the outdoor readings shown on the weather station will not be renewed until the wwvb time signal is successfull...

  • Page 4

    13 will sound for every second. It is possible that your wireless weather station may not be exactly on the second due to the variance in the quartz. However, the clock will adjust the quartz timing over the course of several days to be very accurate; under 0.10 seconds per day. Function keys: the w...

  • Page 5

    17 * when the signal is successfully received by the weather station, the outdoor transmission icon will be switched on. If not successful, the icon will not be shown on lcd. The user can then easily see whether the last reception was successful (icon on) or not (icon off). A short blinking of the i...

  • Page 6

    21 12/24-hour format setting: the hour display can be selected to show hours in 12-hour or 24-hour settings. (default 12-hour) 1. Use the out/+ key to toggle between “12h” or “24h”. 2. Confirm with the set key and enter the manual time setting. Manual time setting: if weather station cannot detect t...

  • Page 7

    25 2. Confirm with the set key and enter the relative air pressure value setting . Note: units of weather icon sensitivity and air pressure history are not affected. They are always expressed in hpa. Relative air pressure value setting the default relative pressure value is 29.92 inhg (1013 hpa). Th...

  • Page 8

    29 indoor relative humidity and indoor temperature: the indoor temperature and humidity data and the indoor comfort indicator are automatically updated and displayed on the second section of the lcd. Indoor relative humidity in rh% indoor temperature in °c or ºf max icon new moon small waxing cresce...

  • Page 9

    33 if the weather station is moved to another location significantly higher or lower than its initial standing point (for example from the ground floor to the upper floors of a house), discard the weather forecast for the next 48- 60 hours. By doing this, the weather station will not mistake the new...

  • Page 10

    37 2. Use out/+ key to view the min/max temperature and humidity data for the selected transmitter. 3. To reset the minimum and maximum temperature and humidity data, and the times at which they were recorded, press the set key continuously for about 3 seconds. This will reset the min/max data recor...

  • Page 11

    41 2. Clip the remote temperature transmitter onto the bracket. Note: the mounting surface can affect the transmission range. If, for instance, the unit is attached to a piece of metal, it may then either reduce or increase the transmitting range. For this reason, we recommend not to place the unit ...

  • Page 12

    45 parts or products if found to be defective during the limited warranty period specified above. All replaced parts and products become the property of la crosse technology, ltd and must be returned to la crosse technology, ltd. Replacement parts and products assume the remaining original warranty,...