1. DL manuals
  2. La Crosse Technology
  3. Weather Station
  4. WS-9210U
  5. Instruction Manual

La Crosse Technology WS-9210U Instruction Manual

Manual is about: Wireless 433 MHz Radio-controlled Temperature Station

Summary of WS-9210U

  • Page 1

    Ws-9210u wireless 433 mhz radio-controlled temperature station instruction manual.

  • Page 2: Topic Page

    2 topic page inventory of contents/additional equipment 3 about wwvb 4 quick set-up guide 5 detailed set-up guide battery installation 6 program mode programming sequence 7 function keys 7 12/24 hour time setting 7-8 time zone setting 8 daylight saving time setting 8-9 time setting (wwvb & manual) 9...

  • Page 3

    3 inventory of contents 1. The weather station (figure 1). 2. One tx6u remote temperature sensor with mounting bracket (figure 2). 3. Three each, ½” philips screws. 4. One strip double-sided adhesive tape. 5. Instruction manual and warranty card. *lcd = liquid crystal display additional equipment (n...

  • Page 4

    4 about wwvb (radio controlled time) the nist (national institute of standards and technology—time and frequency division) wwvb radio station is located in ft. Collins, colorado and transmits the exact time signal continuously throughout the united states at 60 khz. The signal can be received up to ...

  • Page 5

    5 quick set-up guide hint: use good quality alkaline batteries and avoid rechargeable batteries. 1. Have the indoor weather station and remote temperature sensor 3 to 5 apart. 2. Batteries should be out of both units. 3. Place the batteries into the remote temperature sensor first then into the indo...

  • Page 6

    6 detailed set-up guide i. Battery installation a. Remote temperature sensor 1. Remove the mounting bracket. The bracket snaps on and off easily. 2. Remove the battery cover, by sliding the cover down. 3. Observing the correct polarity install 2 aa batteries. The batteries will fit tightly (to avoid...

  • Page 7

    7 program mode programming note: if 30 seconds are allowed to pass or either the in or the out button is pressed during programming modes, the unit will set the last information entered—the display will stop flashing and return to normal time-date readings. If you don’t leave the program mode during...

  • Page 8

    8 2. Press and release the “ch” button to toggle between 12 and 24-hour time. 3. Press and release the “set” button to confirm the 12/24-hour setting and to advance to time zone setting. Iv. Time zone setting the default time zone is est, “zo -5” (eastern standard time), to change this setting: 1. P...

  • Page 9

    9 note: some locations (arizona and parts of indiana) do not follow daylight saving time and should select “dst 0.” 6. Press and release the “set” button to confirm and advance to the time setting mode. Vi. Time there are two methods by which the time can be set: a) automatically via wwvb reception ...

  • Page 10

    10 7. Press and release the “set” button to confirm the minutes and to advance to the day, date, and year setting mode. Note: in 12h mode, “pm” will appear to the left of the time during pm hours. If the time is not within the pm hours, nothing will be displayed. Be sure to set the time to the corre...

  • Page 11

    11 viii. Selecting °f or °c 1. Press and hold the “set” button for 3 seconds, or until “12h” or “24h” flashes in the date lcd. 2. Press and release the “set” button 9 times to reach the °f or °c setting mode. 3. “ °f” is the default setting, and should be flashing in the date lcd. 4. Press and relea...

  • Page 12

    12 features of the ws-9210u i. Indoor temperature the current indoor temperature is displayed in the indoor lcd and is updated every 10 seconds. Ii. Outdoor temperature the outdoor temperature is viewed in the outdoor lcd. The outdoor temperature is updated every five minutes. When there is more tha...

  • Page 13

    13 iii. Minimum and maximum temperature records the ws-9210u keeps a record of the minimum and maximum temperature and the time and date of their occurrence—for both the indoor and outdoor modes. A. Viewing the indoor temperature records 1. Press the “in” button once. “min” appears above the indoor ...

  • Page 14

    14 iv. Alarm function a. Setting the alarm (alarms 1 and 2) note: there are two alarms that can set. Each alarm will sound for a complete duration of 2 minutes. 1. Press and hold the “al1” button for 5 seconds or until the alarm- time display flashes in the date lcd. 2. Press and release the “in” bu...

  • Page 15

    15 their own set of instructions. Follow these instructions for a complete guide to setting up. Following are some brief instructions for the basic set-up of remote temperature sensor units with the ws-9210u. These extra remote temperature sensors can be purchased through the same dealer as this uni...

  • Page 16

    16 the “out” button for 5 seconds, the records for the selected remote temperature sensor unit will be reset. Mounting note: before permanently mounting ensure that the indoor weather station is able to receive wwvb signals from the desired location. Also, extreme and sudden changes in temperature w...

  • Page 17

    17 2) remove the protective strip from one side of the tape. Adhere the tape to the designated area on the back of the mounting bracket. 3) remove the protective strip from the other side of the tape. Position the remote temperature sensor in the desired location, ensuring that the indoor temperatur...

  • Page 18

    18 troubleshooting problem: no reception of wwvb time signal. Solution: 1) wait overnight for signal. 2) be sure indoor weather station is at least 6 feet from any electrical devices such as televisions, computers or other radio-controlled clocks. 3) remove batteries for five minutes, reinsert and l...

  • Page 19

    19 specifications temperature measuring range: indoor: 32 °f to 139°f with 0.2°f resolution (0 °c to 59.9°c with 0.1°c resolution) “ofl” displayed if outside this range outdoor: -21.8 °f to 157.2°f with 0.2°f resolution (-29.9 °c to 69.9°c resolution) “ofl” displayed if outside this range indoor tem...

  • Page 20

    20 la crosse technology, ltd will repair or replace this product, at our option and at no charge as stipulated herein, with new or reconditioned parts or products if found to be defective during the limited warranty period specified above. All replaced parts and products become the property of la cr...

  • Page 21

    21 for warranty work, technical support, or information contact: la crosse technology 2809 losey blvd. S. La crosse, wi 54601 phone: 608.782.1610 fax: 608.796.1020 e-mail: support@lacrossetechnology.Com (warranty work) sales@lacrossetechnology.Com (information on other products) web: www.Lacrossetec...