La Crosse WS-7097U Instruction Manual

Summary of WS-7097U

  • Page 1

    Outdoor temperature sensor world time center • remote transmission of outdoor temperature via 433mhz to base world time center. • lcd display showing current outdoor temperature in fahrenheit (ºf) • shower proof casing • wall mounting case introduction getting started congratulations on purchasing t...

  • Page 2

    To reset the world time center and the outdoor temperature sensor, simply take out the batteries from both unit. Wait for at least 30 seconds and repeat the setup procedure above. • in normal mode display of radio controlled, highly accurate time of day depending on programming - 12 or 24 hours mode...

  • Page 3

    • serves the selection of the displays of current date with weekday, worldtime with location or alternating display of both above modes every 5 seconds on lcd 1. Timezone key • serves to enter the time zone change mode. The preset time zone on lcd 2 will start flashing. By use of the + key the time ...

  • Page 4

    Positioning 1. The hour digits of the worldtime on lcd 1 will start flashing. Select the desired hour by use of the “+” key. Setting of minutes is neither possible nor necessary. Positioning of world time center 2. Press the “set” key to move on to the “ °c/°f setting”. °c/°f setting hanging hole 1....

  • Page 5

    • this product has been designed for strict use in the home as an indicator of the future weather and is not 100% accurate. Weather forecast readings given by this product should be taken only as an indication and not as being totally accurate. • should the world time center be exposed to extreme an...

  • Page 6

    The time base for radio controlled time and date is a operated by the nist radio station wwvb in ft. Collins, colorado. Wwvb broadcasts are used by millions of people throughout the united states to synchronize electronic products like clocks, clock radios and wristwatches. Wwvb continuously broadca...

  • Page 7

    This device complies with part 15 of the fcc rules. Operation is subject to the following two conditions: 1. This device may not cause harmful interference, and 2. This device must accept interference received, including interference that may cause undesired operation..