La Crosse WS-7098U Operating Manual

Summary of WS-7098U

  • Page 1

    Lcd display holder world time center introduction congratulations on purchasing this state-of-the-art world time center as an example of superior design and engineering. Providing radio controlled time, indoor temperature and humidity displays, outdoor temperature, this unit will never keep you gues...

  • Page 2

    Indoor temperature to reset the world time center and the outdoor temperature sensor, simply take out the batteries from both unit. Wait for at least 30 seconds and repeat the setup procedure above. Important! After putting into operation (basic setup or reset) all key functions except for the “set”...

  • Page 3

    Worldtime key • serves the selection of the displays of current date with weekday, worldtime with location or alternating display of both above modes every 5 seconds on lcd 1. Timezone key • serves to enter the time zone change mode. The preset time zone on lcd 2 will start flashing. By use of the +...

  • Page 4

    World time setting 1. The hour digits of the worldtime on lcd 1 will start flashing. Select the desired hour by use of the “+” key. Setting of minutes is neither possible nor necessary. 2. Press the “set” key to move on to the “ °c/°f setting”. °c/°f setting 1. The temperature displays including the...

  • Page 5

    • avoid placing the world time center where it can be exposed to sudden changes in temperature, i.E. Direct sunlight, extreme cold and wet/moist conditions since the design of this product is for indoor use only. This will help to avoid any inaccurate readings and any possible damage to the unit. • ...

  • Page 6

    Warranty information la crosse technology, ltd provides a 1-year limited warranty on this product against manufacturing defects in materials and workmanship. This limited warranty begins on the original date of purchase, is valid only on products purchased and used in north america and only to the o...

  • Page 7

    This device complies with part 15 of the fcc rules. Operation is subject to the following two conditions: 1. This device may not cause harmful interference, and 2. This device must accept interference received, including interference that may cause undesired operation. World time center operating ma...