Ws-8007u 433 mhz radio controlled moon phase clock instruction manual.
2 table of contents topic page inventory of contents/ additional equipment 3 about wwvb 3 quick set-up guide 3 detailed set-up guide battery installation 4 program mode function buttons 5 time zone setting 5 dst (daylight saving time) setting 6 language selection 6 time setting 6 calendar setting 7 ...
3 inventory of contents 1) ws-8007u 2) instruction manual and warranty card. Additional equipment (not included) 1) two fresh 1.5v aa batteries. 2) three wall-hanging screws. 3) appropriate screwdriver for screws. About wwvb (radio controlled time) the nist (national institute of standards and techn...
4 1) observe the correct polarity, and install 2 aa batteries. 2) replace the battery cover. Note: after the batteries have been installed a tone will sound, and all the lcd’s (liquid crystal display) will briefly light up. Then the indoor temperature, the date as “1/ 1”, the weekday as “mon”, and t...
5 i) function buttons there are 4 function buttons located on the backside of the moon phase clock. The function buttons are labeled: “set”, “+”, “alm” and “snz”. Ii) time zone setting 1) hold down the “set” button for 2 seconds, the default setting “-5est” will flash in the date lcd. 2) press and r...
6 2) press and release the “+” button to select the desired language. There are 3 languages to select from: us english f french e spanish 3) press and release the “set” button to confirm the language setting and to advance to manually set the time. V) time setting note: when the wwvb signal is found...
7 18) press and release the “set” button to confirm the calendar settings and to advance to select either 12 or 24-hour time display. Vi) 12/24-hour setting 1) the “12” hour time display will be flashing in the time lcd. 2) press and release the “+” button to toggle between 12 and 24 hour time. Note...
8 5) press and release the “+” button to set the alarm minutes. 6) press and release the “alm” button to confirm and to exit the alarm setting mode. Note: the alarm will be automatically set to sound when exiting the alarm- setting mode, indicated by the alarm icon to the right of the time- ((( •)))...
9 the moon phase clock is programmed with all moon phases and corresponding dates from the year 2000 until 2019. Iv) indoor temperature the indoor temperature appears on the right side of the date lcd. The temperature is checked every 10 seconds, and updated whenever there is a change. Mounting ther...
10 approximately 3/16 of an inch (5mm) extended from the wall. 3) place the moon phase clock onto the screws, using the hanging holes on the backside. Gently pull the moon phase clock down to lock the screws into place. Maintenance & care • extreme temperatures, vibrations, and shock should be avoid...
11 specifications temperature: measuring range: 32 °f to 122°f with 0.2°f resolution (0 °c to 50°c with 0.1°c resolution) checking intervals: every 10 seconds power source: battery type: 2 x aa, iec lr6, 1.5v (alkaline) battery life: approximately 12 months dimensions (l x w x h): 11.4 x 0.98 x 7.5 ...
12 for warranty work, technical support, or information contact: la crosse technology 2809 losey blvd. S. La crosse, wi 54601 phone: 608.782.1610 fax: 608.796.1020 e-mail: support@lacrossetechnology.Com (warranty work) sales@lacrossetechnology.Com (information on other products) web: www.Lacrossetec...
