1 ws-8300u 915 mhz wireless weather station instruction manual.
2 table of contents introduction……………………………………………………………………………………..3 inventory of contents…………………………………………………………………………4 quick set up……………………………………………………………………………………4 detailed set up………………………………………………………………………………4-5 battery installation…………..………………………………………………………..4-5 12 or 24 hour time display………..……...
3 figure 1 instant transmission is the state-of- the-art new wireless transmission technology, exclusively designed and developed by la crosse technology. Instant transmission offers you an immediate update (every 4 seconds!) of all your outdoor data measured from the sensors: follow your climatic v...
4 inventory of contents 1. Wireless weather station (figure 1) 2. Wireless thermo-hygro sensor (tx21u) and mounting bracket. (figure 2) 3. 3 each, 1/2” philips screws. 4. One strip of double sided adhesive tape. 5. Instruction manual and warranty card. Additional equipment (not included) 1. 1 philip...
5 temperatures after the 15 minutes, please retry the set up as stated above. After both indoor and outdoor temperatures are displayed for 15 minutes you can place your thermo-hygro sensor outdoors, and set your time. The remote temperature sensor should be placed in a dry, shaded area. The remote t...
6 a. Thermo-hygro sensor 1. Remove the protective rain cover. 2. Remove the battery cover. 3. Observing the correct polarity, install 2 “aa” alkaline batteries—make sure they do not spring free, or start-up problems may occur. Replace the battery cover. B. Wireless weather station note: after the ba...
7 2. “12h” will begin to flash in the time section of the lcd 3. Press the min/max/+ button to toggle between “12h” and “24h” time. Note: • selecting 12 hour time will automatically select °f as your temperature unit. • selecting 24 hour time will automatically select °c as your temperature unit. 4....
8 displayed. If they are not shown in lcd after 60 seconds, remove the batteries and wait for at least 60 seconds before reinserting them. 4. The outdoor temperature and humidity from the first sensor (channel 1) should then be displayed on the weather station. If this does not happen and the signal...
9 permanently mounting. A. Thermo-hygro sensor 1. Remove the mounting bracket from the thermo-hygro sensor. 2. Mount using either screws or adhesive tape. 3. Reattach the thermo-hygro sensor to the mounting bracket. B. Wireless weather station 1. The wireless weather station comes with the table sta...
10 • clean displays and units with a soft, damp cloth. Do not use solvents or scouring agents; they may mark the displays and casings. • do not submerge in water. • do not subject the units to unnecessary heat or cold by placing them in the oven or freezer. • opening the casings invalidates the warr...
11 warranty information la crosse technology, ltd provides a 1-year limited warranty on this product against manufacturing defects in materials and workmanship. This limited warranty begins on the original date of purchase, is valid only on products purchased and used in north america and only to th...
12 this warranty gives you specific legal rights. You may also have other rights specific to your state. Some states do no allow the exclusion of consequential or incidental damages therefore the above exclusion of limitation may not apply to you. For warranty work, technical support, or information...
