Radio controlled projection clock with digital thermometer instructions manual introduction: projector lens congratulations on purchasing this projection clock with dcf-77 radio-controlled time. The operation of this product is simple and straightforward and by reading this operating manual, users w...
• time projection (hour and minute) • projection with adjustable brightness and projection orientation possible • calendar display (weekday, date, month) • alarm setting with snooze function • time zone (±9 hours) • indoor temperature display in degree celsius • led back-light setting up: the projec...
3. When the batteries are inserted, all the segments of the lcd will light up briefly and a “beep” will sound. The projection clock will now start receiving the dcf time signal. After approximate 3 to 5 minutes, the dcf time will be displayed. 4. If reception is not successful within approximately 7...
1. Connect the power adapter to a wall socket 2. Insert the adapter into the jack at the bottom of the clock 3. The projection clock will now start receiving the dcf time signal. After approximate 3 to 5 minutes, the dcf time will be displayed. 4. If reception is not successful within approximately ...
Batteries powered with the use of ac/dc adapter if the projection clock is first powered by batteries and the power adapter is subsequently used for extended period of time, the main power source of the projection clock will switch to ac/dc power. The batteries will then act as a backup power source...
: toggle between indoor temperature, seconds, alarm time, and date display : enter time zone setting mode : set the minutes, weekday and month : stop alarm and snooze function :back-light-on : set the brightness level of the projection (in a/c power mode) (4 levels: high, medium, low, off) : back-li...
Note: the projector will only project the current time. It will not project the seconds, date or temperature information. Radio controlled time: the time base for the radio-controlled time is a cesium atomic clock operated by the physikalisch technische bundesanstalt braunschweig which has a time de...
Towards the general direction of the frankfurt/main transmitter (avoid positioning within close proximity of metal frames or structures). Note: users may be located in areas where atmospheric disturbances are the direct cause for not receiving the dcf-77 frequency signal. During nighttime, atmospher...
3. Once the alarm time is set, press the snooze key to confirm and exit or wait approximately 8 seconds for automatic timeout. To activate / deactivate the alarm: press the al/hr key. The alarm icon ((( •))) will appear/disappear indicating that it is on or off. Note: the maximum duration of the ala...
Dcf-77 tower icon time date display indoor temperature display in degree celsius seconds display alarm time display 24.
Manual time setting: hours setting (flashing) minutes setting (flashing) in some cases after inserting the batteries, the projection clock may not be able to receive the dcf-77signal. In this situation, the time should be manually set (before manual setting see checking dcf-77 reception above). 1. P...
1. The year digits start flashing. Use the mode/min key to set the year (the range runs from 2000 to 2029). 2. Press the snooze key again to enter the month and date setting (flashing). 3. Use the al/hr key to set the day and the mode/min key to set the month 4. Press the snooze key again to enter t...
Back-light: the led back-light is automatically switched on when any keys are pressed. The back-light will be switched on for approximately 2 seconds before automatically switching off. However, if any of the keys are pressed and held down, then led back-light will remain on constantly unit the key ...
Maintenance: • avoid placing the alarm clock in areas prone to vibration and shock as this may damage and inaccurate readings. • avoid exposure to sudden changes in temperature such as direct sunlight, extreme cold and wet or moist conditions. • when cleaning the display and casing, only use a soft ...
