Lohas t1 important safety instruction ...........1 assembly instruction ......................2 console operation..........................4 preset program ..............................8 utiliztion ..........................................9 maintenance .................................10 congratul...
Front top view 20 00 m m 4 f ee t m in right side left side 1000mm 2 feet min 1000mm 2 feet min danger – to reduce the risk of electrical shock, always unplug this appliance from the electrical outlet immediately after using and before cleaning. ♦ use this appliance only for its intended use as desc...
1: frame 2: base frame 3: support post (left) 4: support post (right) 5: screws 6: nuts 7a: power plug 7b: power wire 8: handlebar 9: console 10: screws 11: bottle holder 12: safety key 13: support post housing (upper left) 14: support post housing (lower left) 15: screws 16: support post housing (u...
Lohas t1 assembly instruction 1. Place the left upper housing (13) into position. (fig.5) 2. Place the lower housing (14) into position ensuring that: a) that the interlocking pins (b of fig.6) slide into position. B) and also the front plastic pin on the lower housing (a of fig.6) fit into the hand...
Lohas t1 console operation start / stop : this will start the treadmill and this will stop the treadmill. There will also be an emergency stop switch. (safety key) incline up > : this will select program / level in setting mode before starting. This will increase the elevation by one increment at a ...
Lohas t1 console operation lohas t1 lohas t1 audio in / out (option) 5.
Lohas t1 console operation under standby status, press the speed “ > ” or “ > ” (incline “ > ” or “ > ”) button to enter the program setting. Program in sequence as below : manual run “manual” → “p1” ~ “p6” → ”user” → ”h.R.C”, when you have chosen desired program, press the mode button to enter deta...
Lohas t1 console operation (1) press the mode button, press the speed “ > ” or “ > ” (incline “ > ” or “ > ”) button to choose h and console shows “program h”. (2) press the mode button, for time, press the speed “ > ” or “ > ” (incline “ > ” or “ > ”) button to choose desired time. Default= 24 minu...
Lohas t1 preset program p1 int 1 int 2 int 3 int 4 int 5 int 6 int 7 int 8 int 9 int 10 int 11 int 12 2 2 3 4 3 2 3 4 3 2 3 2 3 3 4 5 4 3 4 5 4 3 4 3 4 4 5 6 5 4 5 6 5 4 5 4 2 3 4 5 6 7 7 8 8 6 4 2 3 4 5 6 7 8 8 9 9 7 5 3 4 5 6 7 8 9 9 10 10 8 6 4 1 7 2 9 9 2 2 9 9 2 7 1 2 8 3 10 10 3 3 10 10 3 8 2 ...
Utilization ♦ always stretch your muscles before commencing the exercise program. Warm up slowly by walking at a slow speed. Increase workout intensity gradually until you reach your desired workout pace. Decrease workout intensity gradually to an easy walk. Allow your heart rate to decrease to a no...
Maintenance general cleaning 1. Before proceeding, ensure that the treadmill power is off and that it is unplugged from the electrical outlet. 2. Remove dust, use a small vacuum nozzle to carefully vacuum around all visual components. 3. To remove film or dirt use a slightly damp rag with a mild cle...
Maintenance 1.Check the speed sensor if it is damaged or well fixed; the speed sensor has to be fixed where it close to the magnet within 2-3mm. 2.Check the signal cable of speed sensor if it is well connected to the controller. To solve the problem, please reconnect the signal cable to the controll...