La Germania LUG03-90-S Instruction Manual - page 5
5
diagram provided, and should be entrusted to a licensed
specialist. In the event of a damage that occurs as a result of
improper connection, the warranty will be void.
❍ Our appliances meet the applicable safety regulations for
electrical appliances, Repairs may be performed only by
customer service engineers trained by the manufacturer.
Inexpert repairs may entail serious injury to you, the user.
Safety considerations
❍ Never leave the appliance unattended when cooking with
fat or oil. It could ignite if overheated.
❍ In case of a defect, switch off at the mains.
❍ Do not clean the oven with steam or high pressure cleaners.
❍ Ensure that the power cord does not get caught in the hot
oven door. The plastic insulation could melt.
❍ Do not insert a baking sheet or aluminium foil sheet at the
bottom of the oven. A heat build-up could result and cooking
times and temperatures could change or enamel could be
damaged.
❍ Do not pour water on the hot oven floor. Damage to enamel
could result.
❍ Always place a baking tray below a roast to prevent juices
from dripping on the oven lining.
❍ Do not place heavy items on the oven door when open as
this may result in damage to the door hinges.
❍ To ensure correct cooking the oven door must close properly.
Keep the door sealing surfaces clean at all times.
Do not spray aerosols in
vicinity of this appliance
while it is operation.
Where this appliance is
installed in a marine
environment or in
caravans, for safety
reasons it shall not be
used as a space heater.
This appliance is not
intended for use by
persons (including
children) with reduced
physical, sensory or
mental capabilities, or
lack of experience and
knowledge, unless they
have been given
supervision or
instruction concerning
use of the appliance by
a person responsible for
their safely. Children
should be supervised to
ensure that they so not
play with the appliance.
Warning: Accessible
parts will become hot
when in use. To avoid
burns or scalds children
should be kept away.
Warning: In order to
prevent accidental
tipping of the appliance,
for example by a child
climbing onto the oven
door, the stabilising
means must be installed.
Refer to the instructions
for installation.
28
To replace the oven door outer glass panel
1. Remove oven door as per heading ‘To remove the oven door’.
2. Place oven door, glass side down, on a even horizontal
surface.
3. Undo 2 top screws which secure the door handle to the door.
4. Undo 3 screws at the bottom of the door to remove the glass
support strip.
5. Remove the glass panel.
6. Replace the glass panel and reassemble in reverse order.
To replace oven door hinges
1. Remove oven door as per heading ‘To remove the oven door’.
2. Place oven door, glass side down, on a even horizontal
surface.
3. Remove the oven door inner panel as per the heading ‘To
remove the oven door inner glass panel” up to point 4.
4. Remove the 3 retaining screws which secure each hinge to
the oven door inner panel.
5. Slide hinge(s) out and replace. Secure with the 3 retaining
screws.
6. Reassemble the door in reverse order.
7. Ensure that both hinge levers are placed in the upwards
vertical position, relocate the hinges in the oven frame. Swing
the levers back to the horizontal position and close the door.
To replace the under hob cooling fan
Follow procedure described as per heading ‘Access to under
hob area’.
1. Remove electric connections to the fan motor.
2. Remove 4 phillips head screws securing the fan to the
ventilation slot.
3. Replace fan and reassemble in reverse order.