La Germania P6801H9X Installation, Maintenance And Use Instructions

Manual is about: FIXED HOBS WITH GAS OR MIXED SUPPLY

Summary of P6801H9X

  • Page 1

    Instructions for the installation, maintenance and use of fixed hobs with gas or mixed supply 59x50 cm (type p61/p61v) model p6801h9x 86x50 cm (type p91/p91v) model p9101h9x read the instruction booklet before installing and using the appliance. 310693.

  • Page 2

    2 these instructions are valid only for those countries which are indicated by their identification symbol on the front cover of the instruction booklet and on the label on the appliance. The manufacturer cannot be held responsible for any damage to things or persons caused by an incorrect installat...

  • Page 3

    3 l1 min (cm) 6 w (cm) d (cm) l2 min (cm) 4 p6 57 48 l3 min (cm) 10 p9 84 48 l4 min (cm) 70 fixing the hob in order to prevent liquids from accidentally leaking into the kitchen unit underneath the appliance is equipped with a special seal. To put on this seal follow the instructions below very care...

  • Page 4

    4 to the hotplate. The hose should not be subjected to abrasion, kinking or permanent deformation and should be able to be inspected along its entire length. Unions compatible with the hose fittings must be used and connections tested for gas leaks. The supply connection point must be accessible wit...

  • Page 5

    5 warning: if the supply cord is damaged, it must be replaced by the manufacturer or its service agent or a similarly qualified person in order to avoid a hazard. When the connection is made directly with the electricity supply: - make sure that there is a device to disconnect the appliance from the...

  • Page 6

    6 - automatic electric “on” switch: turn the knob corresponding to the selected burner in an anticlockwise direction so that the knob is at maximum (this corresponds to a large flame) and then press in the knob. Let it go as soon as the burner is alight. - “on “ switch for burners with safety device...

  • Page 7

    7 changing the parts before carrying out any maintenance work, disconnect the appliance from the gas and electric supply. To replace different components such as burners, taps and electrical parts you must take out the hob from the kitchen unit by releasing the fixing hooks, unscrew the fixing screw...

  • Page 8

    8 fig.2 fig.3 fig.4 fig.5a fig.5b fig.6a fig.6b fig.7 fig. 8 fig. 9.

  • Page 9

    9 fig.10 fig.11 fig.12 fig.13 fig.14 fig.15 fig.16 fig.17.

  • Page 10

    10

  • Page 11

    11.

  • Page 12

    12 cod. 310981.