P03 / p06 / p09 cod. 2850018 - rev . 00 - marzo 2009 ®.
Introduction dear customer, thank you for choosing our product. This machine, thanks to its reliability, will be able to win your preference also for other products in our range. Each dealer will be able to refer you to the nearest service centre. Notwithstanding the ease of use of the machine, in o...
- 3 - important precautions when using electric material it is important to ensure the appropriate precautions are adopted in order to avoid electric shock, accidents and damage to persons and things. • thoroughly read all information contained in this manual and in any other attachment included in ...
5 • check that the power supply cable is not damaged or defective. If there is a problem, do not use the machine under any circumstances. The power supply cable must be replaced by the manufacturer or by one of its service centres . Pay attention to the position of the cable during installation, it ...
7 operating instructions 1 drip tray 2 cup support grille 3 canister of product a 3 canister of product b 3 canister of product c 4 door 5 water level sensor 6 water tank 7 main switch 8 control panel the figure shows the f09, which has 3 canisters. The f06 and f03 versions differ from this in numbe...
9 • as indicated in the figures of the previous page, the machines have 2 dispensing buttons for each granulated product: - large cup: long dose - small cup: short dose in addition, they have a rinse button for each mixer unit installed. The name assigned to the buttons in the figure (e.G. A1-a2), i...
11 make sure the main switch is set to the position “0” insert the plug in the power outlet. It is important for the power outlet to be compatible with the plug of the machine and provided with the earth connection pin. For correct dispensing, it is important that the product inside the canister nev...
13 pay attention now, the display will indicate the message “ready - sel.Product“ and at this point it will be possible to dispense the desired drink by pressing the corresponding button. Instructions for routine cleaning in order to keep the machine efficient and ensure a long lasting duration, it ...
15 trouble-shooting • the machine dispenses too little water : replace the resin filter fitted on the water intake tube and located inside the water tank. • the machine dispenses one drink and then stops: check the water level in the tank and if necessary refill it or verify that the shut-off valve ...
