Labgear 27884LAB User Manual

The dipole clips onto the central boom. Ensure that the cable 

exit hole (from the terminal box) faces the rear of the aerial 

and that the locating stud fi ts into the locating hole on the 

boom as shown in Fig. 1. 

•

  Wideband - suitable for all UK TV reception areas, covering UHF channels 21 to 68

•

  Receives both digital and analogue TV signals

•

  Perfect for use in the majority of locations although in very high strength signal areas an 

  attenuator may be required, or for very weak strength signal areas an amplifi er may be needed

The aerial requires some assembly - please read these instructions carefully before beginning.

Main Features

1.  Rotate the elements about the central fi xing clip until they 

  ‘snap’ into an upright position as shown in Fig. 2.

2.  The central boom comes in two sections using the bracket supplied and the 

holes drilled in the boom sections join these two sections as shown in Fig. 3.

3.  Attach centre mount bracket in the position shown using  the clips supplied. 

rotate elements

B. Rotating aerial elements, central 

  boom and centre mount assembly  

A. Fitting the dipole assembly

Congratulations on the purchase of your high gain wideband aerial which is designed to receive both analogue and digital terrestrial signals.

This aerial has been manufactured to the standard required to get the best reception of digital terrestrial TV services (such as Freeview™). If the 

aerial is to be used for DTT reception check before installation at www.dtg.org.uk/retailer/coverage to confi rm that your home is in a coverage area 

and to fi nd where your local transmitter is. For optimum results install the aerial using double screened digital coax cable and screened coax outlets.

High Gain Wideband Digital Aerial

27884LAB

1.  Using the refl ector clamps, screw and large wing nut, fi x 

 the 

refl ector assemblies to the main aerial boom.

2.  Check that the refl ector clamp tabs locate in the holes 

of the refl ector boom sections and that the wing nut 

is tight - see Fig. 4.

2.  Ensure that the refl ector elements are facing towards the 

front of the aerial (convex surface forward).

C. Fitting the refl ectors

engage 

tab 

in hole

refl ector 

element

locating 

hole

locating stud

rear of aerial

element 

in upright 

position

refl ector boom 

assembly

central boom

dipole

refl ector 

clamps

USER GUIDE

central boom

back section

central boom

front section

joining bracket with 

bolts and wing nuts

centre mount bracket 

with clips, bolts and 

wing nuts

Fig. 1

Fig. 2

Fig. 3

Fig. 4