Labo ★ k effects – www.Labo-k-effects.Com – karim@labo-k-effects.Com.
Labo ★ k effects – www.Labo-k-effects.Com – karim@labo-k-effects.Com 2 contents contents 2 technical info 3 overview 4 controls 5 power supply 6 power-link system 7 advices 9 troubleshooting 10 recall sheet 11.
Labo ★ k effects – www.Labo-k-effects.Com – karim@labo-k-effects.Com 3 technical info controls ! Output level (volume) ! Tone (tone) ! Distortion amount (drive) ! Behaviour (gate) ! Colour (bright-warm-deep) ! Frequency range (fuzz-fat-ultra) technology ! Selected components ! Robust diecast enclosu...
Labo ★ k effects – www.Labo-k-effects.Com – karim@labo-k-effects.Com 4 overview as its name indicates it, the fuzz ultra is to be classified in the family of fuzz. The fuzz effect describes the sound obtained by the clipping of the signal which presents a wave of square shape. A sensible choice of c...
Labo ★ k effects – www.Labo-k-effects.Com – karim@labo-k-effects.Com 5 controls i – the potentiometers 1. Volume this control adjusts the output level of the ultra fuzz. The normal volume range goes from zero to maximum unless the gate is in action. 2. Tone the tone control acts on the frequency ran...
Labo ★ k effects – www.Labo-k-effects.Com – karim@labo-k-effects.Com 6 power supply labo ★ k effects pedals are powered by 9v dc battery or external power adapter using the « boss ™ » standard (negative (-) in the center, positive (+) outside. The pedal can be supplied in several ways: ! 9v internal...
Labo ★ k effects – www.Labo-k-effects.Com – karim@labo-k-effects.Com 7 power-link system the power-link system of labo ★ k effects allows an external power supply to power several labo ★ k effects pedals via the cable supplied with each pedal by creating a daisy chain. Using the power-link system of...
Labo ★ k effects – www.Labo-k-effects.Com – karim@labo-k-effects.Com 8 use of the power-link cord.
Labo ★ k effects – www.Labo-k-effects.Com – karim@labo-k-effects.Com 9 advices to keep the integrity of the sound, use good quality mono jack cords exclusively. To extend the life of the battery, remove the connector of the input jack when not using the device. Replace the battery when the light shi...
Labo ★ k effects – www.Labo-k-effects.Com – karim@labo-k-effects.Com 10 troubleshooting stage 1 no sound comes out of the device: ! Verify that all your equipment works without the pedal. ! Insert the pedal into the chain. ! If the sound comes out in by pass mode, go directly to the stage 2. If the ...
Labo ★ k effects – www.Labo-k-effects.Com – karim@labo-k-effects.Com 11 recall sheet.
