LabRepCo LABS?62UCRL Instruction Manual - Installing A Panel
12 |
P a g e
5. Screw door panel to frame using 14 screws.
6. Slide frame over refrigerator door and attach with
1 screw on each side on center of door.
7. Attach top brace to frame with 1 screw on each
side. Attach bottom brace in the same manner.
8. Drill a hole through the top and bottom panel using
the braces as a guide with a 1/8” drill bit. Install
screws to finish attaching the top and bottom
braces securely to the frame.
9. Drill a hole into the door panel from the top and
bottom using the braces as a guide with 1/4” drill
bit. Do not exceed 5/8” deep. This is the hole that
the door will pivot on.
10. Remount the door using the supplied top and bottom hinges.
Instructions for Freestanding Use
A1. Remove door from chassis by unscrewing 3 screws in
top hinge and 2 screws in bottom hinge. Keep screws,
discard hinges.
A2. Remove top and bottom hinge bushings.
A3. Remove frame from door.
A4. Attach customer supplied handle to door panel using
countersunk screws.
A5. Screw door panel to frame using 14 screws.
A6. Slide frame over refrigerator door and attach with 3
screw on each side
A7. Install top and bottom hinge bushings.
A8. Remount the door using the supplied top and bottom
hinges.
INTEGRATED FRAMES ARE OPTIONAL ON ALL MODELS.
Installing a Panel
(optional on most counter height models)
Your refrigerator or freezer is fully finished and does not need a front panel. However, if you
have ordered a model with our optional frame, follow the directions below to install your
panel.
1) Prepare your panel. Panel size is 23 1/8” W x 28 1/8” H by 1/4” thick at the edges)
2) Carefully lay the refrigerator (it must be empty) on its back.
3) Unscrew the small piece of frame from the bottom. For a thin metal panel use a backing
piece of cardboard
4) Slide panel into frame and replace the bottom frame and reattach the screws.
5) Lift refrigerator upright carefully.